Aqua PRO APC3000 Bedieningshandleiding - Pagina 7

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Aqua PRO APC3000. Aqua PRO APC3000 11 pagina's. Automatic pool cover pump

Airlock

This pump is a centrifugal utility pump, designed to efficiently remove water. However, it cannot move air. If air is trapped inside the pump

(a condition called "airlock"), the pump cannot pump water out even though the pump is completely submerged. This pump has an airlock

hole. Air flows out through the anti-airlock hole, eliminating the airlock so that the pump can operate properly. If debris blocks the

anti-airlock hole, unplug the pump, reinstall the pump, and restart the pump.

If the pump is suddenly dropped into water, it might take a couple minutes to squeeze air out through the anti-airlock hole.

Alternately, drain the water out of the garden hose, keep the end of the hose out of the water, and plug in the power cord, restarting the

pump.

Care and Cleaning

CAUTION: Always use the handle to lift the pump. Never use the power cord to lift the pump. To avoid skin burns, unplug

the pump and allow time for it to cool after periods of extended use.

When the power is disconnected, inspect the pump inlets and

remove all debris, then plug the pump back into the

grounded (GFCI) outlet.

TO CLEAN THE WATER SENSOR HOUSING

NOTE: Unplug the power cord.

Simple clean the pump

Put the pump upside down and flush the bottom of

the filter base with clean water.

Do Not

Disassemble the motor housing. This motor has NO

repairable internal parts, and disassembly may cause

leakage or dangerous electrical wiring issues.

Lift up the pump by the power cord.