AVProConnect AC-MX88-UHD Gebruikershandleiding - Pagina 6

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} AVProConnect AC-MX88-UHD. AVProConnect AC-MX88-UHD 13 pagina's.

AC-MX44-UHD & AC-MX88-UHD

Press and hold button 3 for 3 seconds to save the setting.

When the LCD shows the following text, or similar:

Then pressing and holding button 3 for three seconds will make the matrix switcher read the EDID

from the display device connected to the selected HDMI output and save it to the input chosen as the

first step in the above table.

Please always be aware that the EDID setting of each input is independent and that, therefore, each

input may need to be programmed separately.

Display IP Information

Press and hold buttons 3 and 4 for three seconds to display the current IP settings. The screen will

change every three seconds to display the next IP setting, but will always begin with the current IP

address of the matrix:

In order to prevent potential IP problems arising, most of the IP settings can only be programmed

using RS232 commands.

Changing the DHCP Setting

Press and hold buttons 1 and 3 for three seconds to change the DHCP setting. The LCD will show the

new DHCP setting:

When the cascading mode is enabled the matrix will not read the EDID or Hot Plug Status from any

display device and will always output the HDMI signal. This mode should only be enabled if the

installation is experiencing some HDMI problems and enabling this mode solves the problem. If the

problems persist when the cascading mode is enabled then there may be a handshaking issue

between the matrix and the display device.

The cascade mode is enabled when the LCD shows the following:

AVProConnect