Aqua Quip InstaTouch Gebruikershandleiding - Pagina 3

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Aqua Quip InstaTouch. Aqua Quip InstaTouch 4 pagina's. Smart lighting controller

Pagina afdrukken

Adjusting the brightness:

The brightness of

and

is normally 100%. The brightness of each zone can be

ZONE-1

ZONE-2

dimmed in four descending steps by:

• Pressing and holding the

button, while then pressing the

button.

ZONE-ON

WHITE

You can change the brightness of ZONE-1 or ZONE-2 separately, or

together.

ZONE 1+2

The brightness of any show or colour can be controlled. If the colour changes to WHITE, you

didn't hold the ZONE-ON button long enough.

The brightness varies in four steps (100%, 70%, 50%, 35%) and returns to 100% on the fifth step.

Re-synchronising your lights:

If your lights are out of synchronisation, try selecting a different colour, then select your

preferred colour or show. Alternatively, reset your lights by pressing ZONE 1+2 ON, then press

the

RED

and

GREEN

and

BLUE

colour buttons simultaneously (needs three fingers).

The lights will turn off for 6.5 seconds. When they turn on again, they will show "blue" colour. The

brightness will be 100% for all lights, and the COLOUR SELECT colour will be reset to "red".

REMOTE CONTROL RECEIVER

The InstaTouch receiver mounts onto the wall with 2 screws, provided. The screw heads should

protrude 5mm off the wall, to allow the screw heads to enter the receptacles in the rear face of

the receiver.

The receiver must be plugged into a standard wall outlet (GPO), and the lighting transformers

plugged into the outlets on the underside of the receiver.

Some retro-fit installations may have the lighting transformers hardwired to the mains

Note:

power supply. If so, a qualified electrician must fit a GPO to the mains power supply and fit three-

pin plugs to the lighting transformers.

DO NOT hardwire the receiver to the mains supply.

The receiver is rated IP33 and should be located under cover, next to the lighting transformers.

The receiver will beep once when power is applied, and beep again five

Receiver Alert Tones:

seconds later. The receiver can be paired with remote handsets during this five-second period

(see below), but not after the five-second beep. The receiver will beep each time a button on a

paired remote is pressed, to acknowledge that it has received a command.

Pairing New or Additional Remotes:

Receivers must be '

paired

' to handsets, so they receive

commands only from your handset. The receiver and handset you purchased together will be

paired already.

Each receiver may be paired with up to eight handsets. When you purchase additional handsets,

or replace a lost handset, it must be paired to your receiver(s). Multiple receivers can be operated

from a single handset.

A handset is paired to a receiver simply by pressing any button on the handset in the first five

seconds of turning power on to the receiver. The easiest way to do this is, turn off the power to

the receiver, bump the remote to wake it up, turn on power to the receiver, press any button on

the remote in the next five seconds and it will be paired.

The receiver will beep as soon as you press the remote's button during the first five seconds. It will

also beep at the end of the five-second period to indicate that it isn't available to pair with remotes any

longer.

S M A R T L I G H T I N G C O N T R O L L E R U S E R G U I D E