CPF Beta Series Handmatig - Pagina 8

Blader online of download pdf Handmatig voor {categorie_naam} CPF Beta Series. CPF Beta Series 8 pagina's. Carbon monoxide detector

Pagina afdrukken

TEST/HUSH BOTTON

Loosen in the slot with a flat screwdriver (Fig.7) and open the cover

below the signal LEDs.

Fig.7

By pressing the TEST / HUSH button (Fig.8) you can:

l Test the operation of the LEDs and BUZZER of the unit when the

detector is in ON mode.

In this case, the detector flashes one by one LEDs, associating each

one with a Beep.

We recommend you to do this at least once a week.

In case of anomalies contact support.

lSilence the BUZZER sound (Beep) when the detector is in FAULT,

END LIFE and LOW BATTERY mode.

The gas detector will stop "beep" for 24 hours while the YELLOW LED

will continue to flash.

After 24 hours the BUZZER will be automatically switched on.

l silence the BUZZER sound (Beep) when the detector is in ALARM

status with a concentration below 300 ppm.

The gas detector will stop "Beep" for 15 minutes while the RED LED

will continue to flash.

After 15 minutes if there is still a concentration of harmful carbon mo-

noxide (CO), BUZZER will be automatically switched on.

In the event of an alarm:

1) Open doors and windows to increase the ventilation of the environment.

2) Close the gas counter tap and stop using any combustion device.

3) If the alarm continues and the cause of gas leak is not detectable

or negligible, abandon the property and, from the outside, alert the

emergency service.

4) If there were people with nausea or headache symptoms, immedi-

ately call the health emergency number.

If the alarm stops, it is necessary to identify the cause that has caused

it and to act accordingly.

GENERAL TERMS OF THE GUARANTEE

THIS CERTIFICATE IS THE ONLY DOCUMENT THAT ENTITLES

YOU TO REPAIR OF THE PRODUCT UNDER THE TERMS OF THE

- The product is GUARANTEED for a period of 24 months from the date of

purchase.

- The GUARANTEE does not cover damage caused by tampering, incorrect

or improper use and installation.

- The GUARANTEE is valid only if it is duly compiled.

- In the event of defects covered by the GUARANTEE, the manufacturer will

repair or substitute the product free of charge.

SERVICING AFTER THE GUARANTEE PERIOD:

Any repairs after the period of the GUARANTEE will be charged on the basis

of the parts substituted and the cost of labour.

GUARANTEE CERTIFICATE

TO COMPILE AND SEND IN CASE OF DAMAGE

760 CO

760/10 CO

DEVICE:

Serial number (s.n.)____________________________________________________

DEALER

Stamp:

USER

Surname and name ____________________________________________________

Address __________________________________________ n°_________________

Postcode ______________________ Town/city _____________________________

Telephone____________________________________________________________

Fig.8

ATTENTION!

GUARANTEE.

SE320EC

SE340EC

Date of purchase:

_____/_____/_____

PERIODICAL VERIFICATIONS

We warmly suggest doing a check-test of the detector working, car-

ried-out from your installer - at least once a year.

To clean the appliance, use a cloth to remove the dust on the case.

Keep in mind that the sensor has good resistance to commonly used

products such as sprays, detergents, alcohol, glues or paints, but

these products can contain substances that, in large quantities, inter-

fere with the sensor causing false alarms.

It is advisable to ventilate the room when using these products.

Solvent or silicone vapors can deteriorate the gas sensor even during

storage in the warehouse.

The use of the gas detector outside the temperature range and hu-

midity indicated may damage the sensor and reduce its life duration.

It is reminded that the detector is unable to detect leaks that occur

outside the room where it is installed either inside the walls or under

the floor.

TO COMPILED BY THE INSTALLER:

Installation date: ______________________________________________

Substituition date: _____________________________________________

Installation local: ______________________________________________

Instruments' serial number:______________________________________

Sign _______________________________________________________

TECHNICAL CHARACTERISTICS

- Power supply:

230Vca- 50/60Hz 2,3VA / 12Vcc 0,6W.

- Sensor type:

Electrochemical sensor.

- Sensor Life:

Beta 762 CO; SE320EC: 6 years in a domestic environment according to specifications.

Beta 762/10 CO; SE40EC: 10 years in a domestic environment according to specifications.

- Working temperature:

-10°C ... +45°C.

- Relative humidity:

30% ... 90% UR.

- Sensor operation limit:

5000 ppm max 15 minutes

- Maximum storage time:

6 months

- Soglie d'intervento:

l 50 ppm for 70 minutes.

l 100 ppm for 20 minutes.

l 300 ppm for 1 minute.

- Acoustic signal:

80 dB (A) to 1 meter.

- Protection degree:

IP42.

- Electronic self-diagnosis with anomaly signal.

- The CO alarm device conforms to the European standard EN 50291-1: 2010 "Electrical

devices for the detection of carbon monoxide in domestic environments".

Directive 2012/19/UE (Waste Electrical and Electronic Equipment - WEEE):

Information for users:

The crossed out wheeled bin label that can be found on your product indicates that

this product should not be disposed of via the normal household waste stream.

To prevent possible harm to the environment or human health please separate this

product from other waste streams to ensure that it can be recycled in an environmen-

tallysound manner. For more details on available collection facilities please contact

your local government office or the retailer where you purchased this product.

Tecnocontrol Srl

Via Miglioli, n°47 20090 Segrate (MI)

Italy Tel. +39 02 26922890

www.tecnocontrol.it

The manufacturer firm reserves the right to make any aesthetic or functional modification to the without prior

notice at any time.

WARNING

(to read on the frontal plastic involucres)

Stamp

GECA Srl

Via E. Fermi, n°98 25064 Gussago (BS)

Italy Tel. +39 030 3730218