Allied Telesis Rapier 48w Hardware installatiehandleiding - Pagina 3

Blader online of download pdf Hardware installatiehandleiding voor {categorie_naam} Allied Telesis Rapier 48w. Allied Telesis Rapier 48w 7 pagina's. Wan capable layer 3 fast ethernet switch
Ook voor Allied Telesis Rapier 48w: Gegevensblad (4 pagina's)

Pagina afdrukken

Models Covered by this Guide

This document describes how to install the AT-FAN04 fan-only module (FOM)

in a Rapier 48w switch.

Package Contents

The following items are included with each FOM:

■

one Installation Guide

■

one warranty card

Installing a Fan-Only Module

Before you begin:

■

Read the safety information for the switch.

Safety information is available in the Rapier 48w Switch Installation and Safety

Guide bundled with every Rapier 48w switch. You can also download this

document from www.alliedtelesis.com/support/software.

■

Gather necessary tools and equipment.

You will need a flat screwdriver to adjust the captive screws on the FOM.

We recommend installing new air filters when you replace a FOM. Air

filters must be purchased separately from your authorised Allied Telesis

distributor or reseller.

■

Verify the package contents if you have not already done so.

See

"Package Contents" on page

reseller if items are damaged or missing.

You do not need to power down the switch to change a FOM, but you should

replace FOMs one at a time.

3. Contact your authorised distributor or

Installation Guide