Allied Telesis Rapier G6 Handleiding voor snelle installatie - Pagina 6
Blader online of download pdf Handleiding voor snelle installatie voor {categorie_naam} Allied Telesis Rapier G6. Allied Telesis Rapier G6 11 pagina's. Rapier switch
Ook voor Allied Telesis Rapier G6: Handleiding voor snelle installatie (12 pagina's), Handleiding voor snelle installatie (13 pagina's), Handleiding voor snelle installatie (12 pagina's)
Pagina afdrukken
6
Figure 1: Rapier front panel and rear panel with AC power inlet.
Front panel
25
26
Uplink Module Bays
Rear panel
100-240 VAC
RPS Inlet for
Power Inlet
AT-PWR8000
10BASE-T / 100BASE-TX
1X
3X
5X
7X
9X
11X
2X
4X
6X
8X
10X
12X
10/100 BASE Expansion Bays
8.
Apply DC power to the switch (for DC models)
Read the Safety and Statutory Information booklet before connecting a DC
power supply. A copy of this booklet is included with each switch. It is also
included on the Documentation and Tools CD-ROM, or can be
downloaded from www.alliedtelesyn.co.nz/support/rapier/.
Only trained and qualified personnel should connect a DC power supply. Due
to exposed terminals, DC powered switches should only be installed in
Restricted Access Areas.
DC supply cable specifications:
•
Number of wires (cores): 3
•
Minimum size: 2.1mm
•
Minimum cable rating: 600V, 90 degrees Celsius
DC power supply specifications:
•
48 V DC (39-60 V DC is acceptable)
•
Either positive grounded or negative grounded
Circuit protection:
•
Use a 10 Amp circuit breaker
To connect the DC supply:
a) Ensure that the supply cable is not live
b) Strip the supply cable wires to expose 8mm (0.31 in.) of bare conductor
c) At the switch, connect the ground wire to the ground terminal (The
terminals can be identified by the diagram on the switch's rear panel,
see Figure 2). Tighten the terminal to between 0.6 and 0.8 Nm (0.041 to
0.055 pound-force per foot)
13X
15X
17X
19X
21X
23X
14X
16X
18X
20X
22X
24X
NSM BAY
2
(14 AWG)
Rapier Switch
Layer 3 Fast Ethernet Switch
PORT ACTIVITY
RS-232
TERMINAL PORT
100M LINK /
ACTIVITY
10M LINK /
ACTIVITY
L /A
FULL DUP
HALF DUP/
COL
D/C
1
3
5
7
9
11
13
15
17
19
21
23
ASYN0
L /A
D/C
L /A
D/C
2
4
6
8
10
12
14
16
18
20
22
24
Port LEDs
System
LEDs
RS-232 Terminal Port
NSM 0
Swap
Hot Swap
In Use
NSM Hot Swap
Button and LEDs
Software Release 2.3.1
C613-04017-01 REV D
STATUS
FAULT
RPS
RESET
PWR