Avsl 178.010UK Gebruikershandleiding - Pagina 4

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Avsl 178.010UK. Avsl 178.010UK 7 pagina's. Active speakers with bluetooth link

Pagina afdrukken

Connections

If a microphone is to be used directly with the CAB speaker, connect via the Mic

Input 1 XLR (5) and select MIC on the mic/line level sector switch (4). Alternatively,

a line input (e.g. CD, mp3 player or laptop) can be connected to the Input 1 jack

socket (6) and the mic/line selector switch set to LINE.

An additional Line input 2 can connect via XLR (14) or dual RCA sockets (13).

Note: Both red and white RCA inputs are summed to mono.

To connect the output of the CAB speaker onto an additional CAB speaker or other

active cabinet, there is an XLR line output (12) which can be linked to a line input

using a good quality balanced audio XLR cable.

Before connecting to mains power, ensure that the supply voltage at the mains

outlet is correct. A covered slide switch (16) can select 110Vac or 230Vac operation

to match the supply voltage. Connect mains to the IEC inlet (7) using the power lead

provided or an equivalent lead with the same fuse and same or higher current rating.

Operation

Before powering up, turn the Bluetooth Volume, Level 1, Level 2 and Master controls

(2, 3, 8, 11) fully down. This will avoid any loud noises or pops when the speaker is

activated. High and Low EQ controls (9, 10) should remain at the 12 o'clock position.

Switch mains power on using the on/off rocker switch (15) and the "ON" LED next to

the Master volume control will light.

If a microphone is connected to Input 1, firstly take care to keep the microphone

pointing away from the front of the speaker, as this can result in feedback.

(howling or squealing noise caused by the microphone "hearing" the speaker output)

Turn up the Master volume (11) part way and gradually increase Level 1 (2) whilst

speaking into the microphone to check for the sound coming through the speaker.

For a line input connected to either input 1 or 2, again with the Master volume

turned up part way, play the audio source (CD, mp3 or other) whilst gradually

increasing Level 1 or Level 2 (2, 8) until the audio can be heard through the speaker.

When all wired inputs have been checked, increase the Master to the maximum

required volume and adjust Level 1 and Level 2 as needed.

CAB Series User Manual