Allied Telesis Rapier AR 700 Series How-To - Pagina 2
Blader online of download pdf How-To voor {categorie_naam} Allied Telesis Rapier AR 700 Series. Allied Telesis Rapier AR 700 Series 8 pagina's. How to set up pppoe between a linux client and access concentrator
Ook voor Allied Telesis Rapier AR 700 Series: Hoe configureren (6 pagina's), Handleiding voor probleemoplossing (8 pagina's), Problemen oplossen (5 pagina's), Handleiding voor snelle installatie (13 pagina's)
Pagina afdrukken
Configuring your Allied Telesis Device
Before starting, ensure that your PC has a version of rp-pppoe.
If rp-pppoe isn't on your PC, do one of the following;
•
Download it from
compile and install it.
•
Use the prepackaged installer, for example RPM or deb.
!
add user=linux_client pass=password
set user=linux_client telnet=no ipaddr=192.168.0.1
#
# PPP templates configuration
#
create ppp template=1
set ppp template=1 bap=off authentication=chap
#
# PPP configuration
#
add ppp acservice=test template=1 vlan=1
ena ppp accessconcentrator
#
# IP configuration
#
enable ip
add ip int=vlan1 ip=192.168.0.254
Network diagram
Linux PC (client)
Set Up PPPoE Between a Linux Client and an Allied Telesis Access Concentrator
http://www.roaringpenguin.com/penguin/open_source_rp-pppoe.php
Configure your Allied Telesis device as follows:
netmask=255.255.255.255
eth 1
port 1
Allied Telesis switch
(Access Concentrator)
, then
2