Allied Telesis Rapier i series Handleiding voor probleemoplossing - Pagina 6
Blader online of download pdf Handleiding voor probleemoplossing voor {categorie_naam} Allied Telesis Rapier i series. Allied Telesis Rapier i series 8 pagina's. Virtual router redundancy protocol
Ook voor Allied Telesis Rapier i series: Problemen oplossen (5 pagina's), Hoe configureren (9 pagina's)
Pagina afdrukken
When it comes to diagnosing an ISDN connection, the two most important columns in this
table are Duration and Cause.
The Duration column
The Duration column tells you immediately whether or not the call ever connected. If the
entry in this column is CLEARED, then the call never connected. If the entry in this column is
a time, then the call did actually connect at the ISDN level. The reason why you were unable
to get data across will be found at a higher protocol level (PPP or IP, IPX etc). Typically, if the
duration of the call was one or two seconds, then the call would have been closed due to a
PPP negotiation failure. One of the most common causes of PPP negotiation failure is due to
PAP or CHAP authentication failing. This can be quickly checked by looking in the router log,
using the command:
A PAP or CHAP authentication failure generates a log message of the form
Note:
If the call is being disconnected due to PAP/CHAP negotiation failure, see How To Configure
PPP Authentication using PAP and CHAP for a full discussion on configuring PAP and CHAP on
the router. This How To Note is available from
howto.aspx
If the call seems to be being disconnected for other reasons at the PPP or IP level, then it
would probably be necessary for you to contact your Allied Telesis reseller or distributor for
technical assistance.
The Cause column
The Cause column tells you why a call was disconnected. Each entry in this column has three
parts:
1.
2.
3.
The cause code number can give you a lot of information about why your call is not working.
Values commonly seen for this code are:
6
show log
01 01:16:06 5 PPP
isdn-dial1 failed
The log message appears on the router that is doing the authenticating, which may
well be the router at the other end of the link. The way to tell which router decided
to close the call is to check the Cause column.
A letter indicating which end of the link took the call down. U (for User) indicates that the
router itself closed the call. N (for network) indicates the call was closed either by a switch
in the ISDN network, or by the router at the other end of the call.
A cause code number, indicating the reason for the call closure.
An extra diagnostic number. The meaning of this diagnostic number varies from one cause
code to the next. For most cause codes, this field is actually blank. It is necessary to have
a good working knowledge of ISDN and access to ISDN standards manuals in order to
make any use of these diagnostic numbers.
16 - Normal
The call opened and was then closed by an indication from a higher layer protocol that it
was time to close the call. So, any successful call that passes data, and then is closed due
to the PPP idle timer timing out due to no more data being sent, has a cause code of 16.
AUTH
FAIL
ppp0: PAP authentication over
www.alliedtelesis.com/resources/literature/