Dell Inspiron 600m Servicehandleiding - Pagina 9

Blader online of download pdf Servicehandleiding voor {categorie_naam} Dell Inspiron 600m. Dell Inspiron 600m 41 pagina's. Hard drive
Ook voor Dell Inspiron 600m: Start Here (2 pagina's), Start Here (2 pagina's), Start Here (2 pagina's), Aan de slag handleiding (2 pagina's), Gebruikershandleiding (34 pagina's), Installatiehandleiding (2 pagina's), Aan de slag (2 pagina's), Installatiehandleiding (2 pagina's), Installatiehandleiding (2 pagina's), Installatiehandleiding (2 pagina's), Installatiehandleiding (2 pagina's), Installatiehandleiding (2 pagina's), Installatiehandleiding (2 pagina's), Installatiehandleiding (2 pagina's), Gebruikershandleiding Mediabasis (26 pagina's), Servicehandleiding (40 pagina's), Servicehandleiding (41 pagina's), Installeren en configureren (38 pagina's), Snel aan de slag (2 pagina's), Snel aan de slag (2 pagina's), Snel aan de slag (2 pagina's), Uw computer instellen (2 pagina's), Servicehandleiding (41 pagina's), Servicehandleiding (4 pagina's)

Back to Contents Page

Microprocessor Module

Dell™ Inspiron™ 600m Service Manual

CAUTION:

Before performing the following procedures, read the safety instructions in your Owner's Manual.

NOTICE:

To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such

as the back panel) on the computer.

NOTICE:

Do not touch the processor die. Press and hold the microprocessor down on the substrate on which the die is mounted while turning the cam

screw to prevent intermittent contact between the cam screw and microprocessor.

NOTICE:

To avoid damage to the microprocessor, hold the screwdriver so that it is perpendicular to the microprocessor when turning the cam screw.

1. Follow the instructions in

"Preparing to Work Inside the

2. Remove the keyboard.

NOTICE:

To ensure maximum cooling for the microprocessor, do not touch the heat transfer areas on the microprocessor thermal-cooling assembly. The

oils in your skin reduce the heat transfer capability of the thermal pads.

3. Remove the

microprocessor thermal-cooling

NOTICE:

When removing the microprocessor module, pull the module straight up. Be careful not to bend the pins on the microprocessor module.

4. To loosen the ZIF socket, use a small, flat-blade screwdriver and rotate the ZIF-socket cam screw counterclockwise until it comes to the cam stop.

1 screwdriver (perpendicular

to microprocessor)

2 ZIF-socket cam screw

3 ZIF socket

4 pin-1 corner

NOTE:

The ZIF-socket cam screw secures the microprocessor to the system board. Take note of the arrow on the ZIF-socket cam screw.

5. Lift out the microprocessor module.

Installing the Microprocessor Module

Computer."

assembly.