Allied Telesis AR400 Series Handleiding voor probleemoplossing

Blader online of download pdf Handleiding voor probleemoplossing voor {categorie_naam} Allied Telesis AR400 Series. Allied Telesis AR400 Series 8 pagina's. How to set up pppoe between a linux client and access concentrator
Ook voor Allied Telesis AR400 Series: Hoe configureren (6 pagina's), Problemen oplossen (5 pagina's), Handleiding voor snelle installatie (8 pagina's), Handleiding voor snelle installatie (12 pagina's), Handleiding veiligheidsinformatie (18 pagina's), How-To (8 pagina's)

How To |

Troubleshoot ISDN Connections

Introduction

Ideally, setting up an ISDN connection is very much a straightforward process:

Connect the router to the ISDN network interface.

Configure ISDN call definitions on the router. See How To Configure ISDN Calls On Allied

Telesis Routers, available from www.alliedtelesis.com/resources/literature/howto.aspx.

Send traffic.

However, for one reason or another, there are occasions when the setup process is not as

smooth as it should be.

So if you have set up your router to communicate over ISDN, but the setup does not appear

to be working, this How To Note contains some steps you can take to try and resolve the

problem.

Which products does it apply to?

This configuration applies to the following Allied Telesis routers and switches, when a BRI or

PRI interface is installed in the base unit or through a PIC:

AR300 series routers

AR400 series routers

AR700 series routers

Rapier series switches

Rapier i series switches

Related How To Notes

You also may find the following How To Notes useful:

How To Configure ISDN Calls On Allied Telesis Routers

How To Configure Common ISDN Access Concentration With The Firewall

How To Notes are available from www.alliedtelesis.com/resources/literature/howto.aspx.

C613-16030-00 REV B