8 7 7 . 4 4 9 . 0 4 5 8
F o r mo r e i n f o r ma t i o n , p l e a s e c a l l
Quick Start Guide
/
AER1600 Series
HARDWARE
2
S a l e s @C o r p o r a t e A r mo r . c o m
, o r e ma i l u s a t
.
LED Indicators
Power LED:
AER1600/AER1650 must be
powered using an approved
12V DC power source.
+ Green = Powered ON
+ No Light = Not receiving power.
Check the power switch and the
power source connection.
+ Flashing Amber = Attention.
Open the administration pages
(see page 4) and check the
router status.
Ethernet WAN:
information about a data source
connected to the Ethernet WAN
port.
+ Blue = Connected to an active
Ethernet WAN interface
VPN:
Indicates information about a
VPN data source.
+ Green = Active VPN tunnel
Embedded Modem:
status of embedded modem (only
on AER1600LPE/AER1650LPE).
Removable MC400 Modem:
Indicates the status of removable
MC400 modem.
Additional LED Indications
+ Several different LEDs flash
when the factory reset button
is detected.
©2005-2016 Cradlepoint. All Rights Reserved.
The Cradlepoint
External USB Modem:
status of external USB modem. All
modems have the following LED
indicators:
+ Green = Modem has established
an active connection.
+ Blinking Green = Modem is
connecting.
+ Amber = Modem is not active.
+ Blinking Amber = Data
connection error. No modem
connection possible.
+ Blinking Red = Modem is in the
Indicates
process of resetting.
Signal Strength:
Blue LED bars
indicate the active modem's signal
strength.
+ 4 Solid Bars = Strongest signal
+ 1 Blinking Bar = Weakest signal.
(A blinking bar indicates half
of a bar.)
Indicates the
WiFi Broadcast:
(AER1600 only)
These two LEDs indicate activity on
the WiFi broadcast for both the 2.4
GHz and 5 GHz bands.
+ 2.4GHz (green) = 2.4 GHz WiFi is
on and operating normally.
+ 5GHz (blue) = 5 GHz WiFi is on
and operating normally.
+ Two of the modem LEDs blink
red in unison for 10 seconds
when there is an error during
firmware upgrade.
|
+1.855.813.3385
|
cradlepoint.com
Indicates the
Pagina afdrukken