DH AZ-EL Handleiding voor installatie-instructies - Pagina 7

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} DH AZ-EL. DH AZ-EL 20 pagina's.

Pagina afdrukken

"OPTIONAL ASSEMBLY METHOD"

(Install By Sections: Using 2-3 People)

Assemble mount , using the elevation tube to place mount in birdbath position. Be sure to tighten the

elevation tube and lock the mount with ratchet straps once in birdbath position. (See PHOTO D)

Step 1: Install the brace clips to all 8 back braces,

only tighten these 'finger tight'. Next, install a ½" nut at the end of the back brace, threading it down

approximately 4 to 4 ½" down the threaded rod. (See FIGURE #7)

Step 2: Install the bent tabs to the 48" Ring.

½" x 3" long with two holes (you will find these in the bolt bag). Fasten the bent tabs with ½" bolts, and a ½" nut.

(See FIGURE #8)

Step 3: Take the first panel(the panel that has the pilot hole) and install it to the ring of the mount finger tight. Be

sure to start with the pilot hole on the mount and on the antenna. Take the back brace that is ready and put the

threaded rod through the tab on the ring (see PHOTOS A & B). Take the other end of the rod with the clip and

attach the brace and clip to the lip of the antenna section (see PHOTO C).

Step 4: Insert ½" x 3" bolt (see FIGURE #10) for washers and rubber placement) from the antenna to the mount.

Have one person continue holding the panel in place while the second person attaches the back brace. (Remember

the threaded end of the back brace should already have the ½" nut on the threaded end about 4-4 ½" on the

threaded rod and the bent tab already installed on the ring, (see FIGURE #8). Insert the threaded rod of the back

brace into the bent tab and bolt brace clip on the edge of the antenna with ¼" x ¾" bolt, ¼" nut and ¼" lock

washer. Make sure everything is only 'finger tight'.

Step 5: Pick up the second antenna panel and be sure the numbers line up(so "2" mates up to "2", "3 to ", etc. and

bolt in place just like the first panel. (see FIGURE #9) Once secure you can begin bolting the two units together by

placing the 3/8" x 1" bolts and washer through the templates. Secure with washer, lock washer and nut and only

'finger tight'. Continue for the remaining panels. Once all sections have been installed, securely tighten all of the

hardware.

STEP 6: You will notice all 8 bolts in the face of the antenna have been installed from the antenna to the ring at this

point. You now remove every other bolt from the face of the antenna and replace them with a feed strut. (See

preparing the feed assembly on page 9)

FIGURE #7

48" RING

1/2" x 1 1/2" Bolt

Back braces are measured by tube

length only.

FIGURE #10

using a 3/8" x 2" bolt, 3/8" nut and a 3/8" lock washer.

The bent tabs are a piece of steel bent in the middle, approximately 1

FIGURE #8

Block

1/2" x 3" Bolt

PHOTO A

PHOTO B

PHOTO D

Initially,

Brace Clip

PHOTO C

Brace Tab

Match 2 with 2

FIGURE #9

Page 5