Dell 1555 - Studio - Chainlink Servicehandleiding - Pagina 30
Blader online of download pdf Servicehandleiding voor {categorie_naam} Dell 1555 - Studio - Chainlink. Dell 1555 - Studio - Chainlink 50 pagina's.
Ook voor Dell 1555 - Studio - Chainlink: Servicehandleiding (50 pagina's)
Back to Contents Page
Memory
Dell Studio™ 1555 Service Manual
Removing the Memory Module(s)
Replacing the Memory Module(s)
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on the back of the computer).
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
inside the computer.
You can increase your computer memory by installing memory modules on the system board. See "Specifications" in your Setup Guide for information on the
memory supported by your computer. Install only memory modules that are intended for your computer.
NOTE:
Memory modules purchased from Dell™ are covered under your computer warranty.
Your computer has two user-accessible SODIMM sockets, DIMM A and DIMM B, accessed from the bottom of the computer.
CAUTION:
If you need to install memory modules in two connectors, install a memory module in the connector labeled "DIMM A" before you
install a module in the connector labeled "DIMM B."
Removing the Memory Module(s)
1. Follow the procedures in
Before You
2. Remove the base cover (see
CAUTION:
To prevent damage to the memory module connector, do not use tools to spread the memory module securing clips.
3. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.
4. Remove the module from the connector.
1
memory module connector
3
memory module
Replacing the Memory Module(s)
1. Align the notch in the module edge connector with the tab in the connector slot.
2. Slide the module firmly into the slot at a 45-degree angle, and press the module down until it clicks into place. If you do not hear the click, remove the
Begin.
Removing the Base
Cover).
2
securing clips (2)
Before Working Inside Your
Computer) before working