Dell Dimension 2400 Series Handmatig - Pagina 32

Blader online of download pdf Handmatig voor {categorie_naam} Dell Dimension 2400 Series. Dell Dimension 2400 Series 43 pagina's. Vga card installation instructions
Ook voor Dell Dimension 2400 Series: Handleiding voor snelle installatie (2 pagina's), Handleiding voor snelle installatie (2 pagina's), Installatiehandleiding (20 pagina's), Installatiehandleiding (8 pagina's), Instructies voor installatie van het rek (32 pagina's), Installatie-instructies (1 pagina's)

Dell Dimension 2400 Series Handmatig
13.  Lift the system board out from the computer.
14.  Place the system board that you just removed next to the replacement system board.
 
Visually compare the replacement system board to the existing system board to ensure that you have the correct part.
 

Installing the System Board

1.  Transfer components from the existing system board to the replacement system board:
a.
 Remove the memory modules and install them
 
CAUTION:
The microprocessor package can get hot. To avoid burns, ensure that the package has had sufficient time to cool before you touch it.
b.
 Remove the microprocessor package
2.  Configure the settings of the replacement system board.
 
Set the jumpers on the replacement system board so that they are identical to the ones on the existing board.
3.  Place the system board inside the computer frame, place the heat-sink base on the system board, and then replace the screws that you removed in
step 12
of the preceding procedure.
4.  Reinstall the fan assembly.
5.
 Reinstall the microprocessor heat
6.  Reattach the cables to the system board.
7.
 Reinstall any
cards.
8.
 Replace the floppy
drive.
9.
 Replace the computer
cover.
 
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
10.  Connect your computer and devices to electrical outlets, and turn them on.
Back to Contents Page
 
on the replacement board.
from the existing system board and transfer it to the replacement system board.
sink, and then lower the heat-sink shroud.