Dell Dimension 2400 Series Handmatig - Pagina 5

Blader online of download pdf Handmatig voor {categorie_naam} Dell Dimension 2400 Series. Dell Dimension 2400 Series 43 pagina's. Vga card installation instructions
Ook voor Dell Dimension 2400 Series: Handleiding voor snelle installatie (2 pagina's), Handleiding voor snelle installatie (2 pagina's), Installatiehandleiding (20 pagina's), Installatiehandleiding (8 pagina's), Instructies voor installatie van het rek (32 pagina's), Installatie-instructies (1 pagina's)

Back to Contents Page

Battery

Dell™ Dimension™ 2400 Series

CAUTION:

Before you begin any of the procedures in this section, follow the safety instructions in your Owner's Manual or Product Information

Guide.

A coin-cell battery maintains computer configuration, date, and time information. The battery can last several years.

If you have to repeatedly reset time and date information after turning on the computer, replace the battery.

CAUTION:

A new battery can explode if it is incorrectly installed. Replace the 3-V CR2032 battery only with the same or equivalent type

recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions.

1. Record all the screens in the

Remove the computer

cover.

Locate the battery

socket.

4. Remove the battery by carefully prying it out of its socket with your fingers or with a blunt, nonconducting object such as a plastic screwdriver.

NOTICE:

To avoid damage to the system board while you pry the battery loose, be sure to insert the plastic screwdriver between the battery and the

socket (not the system board).

5. Insert the new battery into the socket with the side labeled "+" facing up and snap the battery into place.

NOTICE:

To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.

Replace the computer

cover.

7. Connect your computer and devices to electrical outlets, and turn them on.

8. Access the

system setup program

9. Properly dispose of the old battery. See the safety instructions in your Owner's Manual or Product Information Guide.

Back to Contents Page

system setup program

so that you can restore the correct settings when your perform step 8.

and restore the settings you recorded in step 1.