Cradlepoint CR4250 Snelstarthandleiding - Pagina 3
Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Cradlepoint CR4250. Cradlepoint CR4250 5 pagina's. High-performance branch router
Pagina afdrukken
11/2/2020
Ensure power is switched on (O = OFF, – = ON):
When you set the power switch to the ON ( – ) position; watch for the power LED to illuminate. Refer to the Understanding LEDs section of this
document for more information about LED lights on the CR4250 router.
3. Once the device is powered on, log into NetCloud manager and complete the device setup. Refer to the Connecting to NetCloud section in this
document for more information.
Understanding LEDs
INDICATOR
BEHAVIOR
Power: The CR4250 must be powered using an approved power source. Input requirements:
100-240V, 50-60Hz; 1.7A max without PoE, 4.1A max with PoE.
LED Off = normal operation
Status LED
Blinking Green (1Hz) = upgrade in progress OR a button is currently pressed
Blinking Green (4Hz) = shutdown in progress
Blinking Orange (4Hz) = factory reset in progress
Green = Powered ON and hardware OK
No Light = Not receiving power. Check the power source connection
Red = Critical hardware problem detected. Hardware problem means that, most likely, unit
Power LED
can not boot. This can happen when hardware component (RAM, CPU, Flash, etc) was
found to have a critical issue and can't operate as expected. Contact Support.
Press and hold for more than 3 seconds, but less than 7 (status LED will be flashing green
at 4Hz when button released). Unit will send shutdown signal to all of its components and
Power
will safely power down. The PWR LED will turn RED before turning off completely.
Button
Press and hold for more than 7 seconds. Unit will do the same thing as above, but will force
shutdown of all components.
To reset the device, press and hold for more than 7 seconds (status LED will be flashing
Reset
orange at 4Hz when button is released). Customer configuration will be erased and unit will
Button
reboot. Customer entitlements will be preserved.
Return to the Top
Connecting to NetCloud
Activate your device through NetCloud Manager (NCM). Your device is packaged with NetCloud services and requires that you log into your NetCloud
account to activate your device. Refer to the following for more information:
Getting Started with NetCloud (https://customer.cradlepoint.com/s/article/Getting-Started-with-NetCloud-Manager)
Troubleshooting
https://customer.cradlepoint.com/s/article/CR4250-Getting-Started
CR4250 High-Performance Branch Router Quick Start Guide
3/5