Allied Telesis 86241-02 Release Release - Pagina 6

Blader online of download pdf Release Release voor {categorie_naam} Allied Telesis 86241-02. Allied Telesis 86241-02 12 pagina's. Patch for rapier switches and ar800 series modular switching routers

Pagina afdrukken

PCR: 02346

Module: BGP, IPG

It is now possible to set a preference value for dynamically learned routes

based on their protocol using the command:

SET IP ROUTE PREFERENCE={DEFAULT|1..65535}

PROTOCOL={BGP-EXT|BGP-INT|OSPF-EXT1|OSPF-EXT2|OSPF-INTER|

OSPF-INTRA|OSPF-OTHER|RIP}

PCR: 02347

Module: SWI

The CREATE CONFIGURATION command was not correctly generating

the DISABLE SWITCH HWFILTER and DISABLE SWITCH L3FILTER

commands. This issue has been resolved.

PCR: 02348

Module: ENCO

When the PAC card was under severe load, the related driver occasionally

did not fully transfer all result data from the chip. This caused an actCmdFail

error. This issue has been resolved.

PCR: 02354

Module: SCC, SYN, PPP

In a previous patch, a fatal error occurred after a RESTART ROUTER

command was executed when using PPP over SYN. Also, on AR745

models, PPP was using an 8 MB boundary instead of a 16 MB boundary.

These issues have been resolved.

PCR: 02357

Module: FR

The following issues have been resolved:

•

PIM was not sending Hello messages over a Frame Relay (FR) interface.

•

A fatal error occurred if 64 was entered as the interface value in the

DESTROY FRAMERELAY command. The command now only accepts

0-63 for this parameter.

•

The ADD FRAMERELAY DLC command incorrectly accepted a TYPE

parameter. Also, this command was not accepting the

ENCAPSULATION parameter.

•

The CREATE CONFIGURATION command incorrectly generated the

CIR and CIRLIMITED parameters for the ADD FRAMERELAY DLC

command.

•

FR interfaces with static DLCs were always shown as DOWN. The

status of the interface was not being updated when a circuit was added

to the interface.

PCR: 02359

Module: IPG

When an IP Multihomed interface was used as an OSPF interface,

neighbour relationships were only established if the IP interface for OSPF

was added first in the configuration. Now, OSPF establishes neighbour

relationships regardless of the IP Multihomed interface configuration order.

PCR: 02363

Module: FFS, FILE, TTY

The FLASH compaction process is now transparent to the file edition

process. The FLASH system is now more stable.

Patch Release Note

Network affecting: No

Patch 86241-02 for Software Release 2.4.1

C613-10340-00 REV B