Dell XPS 430 Servicehandleiding - Pagina 12

Blader online of download pdf Servicehandleiding voor {categorie_naam} Dell XPS 430. Dell XPS 430 42 pagina's. Dell xps computer setup
Ook voor Dell XPS 430: Instellen (2 pagina's)

Pagina afdrukken
Dell XPS 430 Servicehandleiding
 
7. Check the documentation that came with the drive to verify that the drive is configured for your computer.
 
8. If your replacement hard drive does not have the hard-drive bracket attached, remove the bracket from the old hard drive by unsnapping it from the
drive.
 
9. Snap the hard-drive bracket onto the replacement hard drive.
1
hard drive
 
10. Install the hard drive into the computer by sliding the drive into place until it clicks into place.
 
11. Connect the power and hard drive cables to the hard drive.
 
12. Check all connectors to be certain that they are properly cabled and firmly seated. 
 
13. Replace the computer cover (see
 
14. Connect your computer and devices to electrical outlets, and then turn them on.
 
15. If installing this drive changes the drive configuration, ensure that you reflect these changes in the BIOS. When you restart your computer, enter system
setup (see
System
Setup). On the setup screen go to the "Drives" section and set the SATA ports (SATA 0 through 4) to the correct configuration.
 
16. See the documentation that came with the hard drive for instructions about installing any software required for the operation of the hard drive.
 

Installing a Hard Drive in the FlexBay

The top FlexBay drive on your system can hold an additional hard drive.
1
hard drive
2
sliding plate lever
 
1. Follow the procedures in
Before You
 
2. Remove the computer cover (see
 
3. Remove the drive panel (see
 
4. Remove the shoulder screws from the inside of the drive-panel insert and attach the screws to the new drive (see
 
5. Turn the FlexBay knob on the cage by 90 degrees, in the anti-clockwise direction.
NOTICE:
Ensure the FlexBay knob is turned in the anticlockwise direction, failing which can result in the knob being broken.
NOTE:
Turning the FlexBay knob once opens up the drive space to accommodate a larger device like a hard drive. The knob at this stage is in a
horizontal position.
2
hard-drive bracket
Replacing the Computer
Cover).
3
flexbay knob (default position)
Begin.
Removing the Computer
Cover).
Replacing the Drive
Panel).
Replacing the Drive-Panel
Insert).