Dell 6100 Aanvullende handleiding - Pagina 2

Blader online of download pdf Aanvullende handleiding voor {categorie_naam} Dell 6100. Dell 6100 4 pagina's. Dell poweredge 4200 servers: installation guide
Ook voor Dell 6100: Installatie rek (37 pagina's), Hardware Handleiding (15 pagina's), Installatie rek (34 pagina's)

Pagina afdrukken

Systems With More Than 2 GB of

Memory and a RAID Controller

If your Dell PowerEdge 6100 system has more than 2 GB

of memory and a Dell PowerEdge Expandable RAID

controller, you must have the following to perform the

memory upgrade:

•

System: BIOS version A06 or later

•

Controller: Firmware version U.77 or later

If you have an earlier version of the BIOS, contact Dell

for an upgrade. (See the chapter titled "Getting Help" in

the Dell PowerEdge 6100/200 System Installation and

Troubleshooting Guide.)

Refer to the Dell PowerEdge Expandable RAID control-

ler documentation for more information.

DIMM Installation Guidelines

When installing DIMMs, populate the DIMM sockets

from J2 through J33 consecutively, using groups of four

DIMMs. For example, you must install the first four

DIMMs in sockets J2, J3, J4 and J5 (see Figure 1 for

socket locations).

CAUTION: Handle DIMMs carefully. Hold them

only by their edges. Do not slide them across any

surface. Applying too much pressure on retaining

clips can break the clips or damage the socket.

The 4-GB memory module supports error detection and

correction, memory downsizing, and address-bit permut-

ing. All configurations result in four-way interleaving.

The total memory reported by the system will be 32 MB

less than the actual memory installed. For example, if

your system has 4 GB of memory, it will report 4064 MB

instead of 4096 MB. The top 32 MB is reserved for the

basic input/output system (BIOS), Peripheral Component

Interconnect (PCI) devices, and event log area.

pin 1 end

J30

Figure 1. Memory Module and DIMM Sockets

Table 1 lists the possible memory configurations.

Table 1. DIMM Configurations

Total

Desired

Memory

Sockets Populated

0.5 GB

J2–J5

1.0 GB

J2–J9

1.5 GB

J2–J13

2.0 GB

J2–J17

2.5 GB

J2–J21

3.0 GB

J2–J25

3.5 GB

J2–J29

4.0 GB

J2–J33

Performing a Memory Upgrade

WARNING: The power supplies in this computer

produce high voltages and energy hazards, which

can cause bodily harm. Only trained service techni-

cians are authorized to remove the computer

covers and access any of the components inside the

computer.

J33

pin 1