Dell D90DW Installatiehandleiding - Pagina 8

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Dell D90DW. Dell D90DW 24 pagina's. D class cloud clients
Ook voor Dell D90DW: Snelstarthandleiding (6 pagina's), Snelstarthandleiding (8 pagina's), Snelstarthandleiding (6 pagina's), Snelstarthandleiding (6 pagina's), Snelstarthandleiding (8 pagina's), Snelstarthandleiding (10 pagina's)

Dell D90DW Installatiehandleiding
Chapter 2
4
4. Place your thumbs on the top surface of the opposite end where the three screws
Figure 2 Removing the cover
5. Remove the cover to expose the main-board shield.
Figure 3 Main-board shield
6. Using the Phillips Screwdriver, remove the five screws from the main-board shield
were removed. With a continuous motion, push firmly downward and towards the
back panel (pushing down unlatches the hooks under the cover). The cover will
shift approximate 1/4 inch to hang over the back panel. (a) Grasp the overhanging
cover edge and raise the edge about 1-1/2 inches, and then (b) pull the cover out
towards the back panel at the same angle to free the opposite end of the cover from
the remaining hooks, as shown in Figure 2.
(four corner screws and one screw mid-way along the front edge). Remove the
main-board shield and unplug the speaker wire (red wire) to expose the main board
and Flash module as shown in Figure 4.
WARNING: Flash modules may be susceptible to damage by Electro-Static
Discharge (ESD). All industry-standard cautions should be followed to avoid ESD.
Before you remove or install a module, touch any metal part of the chassis and keep
that contact with the chassis during the installation process.