Dell Dimension 2200 Handmatig - Pagina 15

Blader online of download pdf Handmatig voor {categorie_naam} Dell Dimension 2200. Dell Dimension 2200 50 pagina's. Vga card installation instructions
Ook voor Dell Dimension 2200: Vervangingshandleiding (9 pagina's), Installatie-instructies (1 pagina's)

Pagina afdrukken
Dell Dimension 2200 Handmatig
NOTICE:
To connect a network cable, first plug the cable in to the network wall jack and then plug it in to the computer.
18.  See the drive's documentation for instructions on installing any software required for drive operation.

Hard Drive

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
1.
 Shut down the
computer.
2.  Turn off any attached devices and disconnect them from their electrical outlets.
NOTICE:
To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.
3.  Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board.
4.
 Remove the computer
cover.
5.
 Remove the front
panel.
6.
 Rotate the power supply
away from the system board.
7.  While holding the power supply, place the computer in the upright position.
8.  Remove the two screws securing the hard drive to the front of the computer frame.
 
9.  Release the clip that secures the drive to the computer frame, and rotate the drive out of the computer.
10.  Disconnect the power and interface cables attached to the drive.
11.  Remove the existing drive from the bay.
To reinstall the primary hard drive:
NOTICE:
When you reinstall the hard drive, make sure that the control panel wires are not caught underneath the hard drive.
1.  Orient the new drive with its circuit board facing the front of the computer frame.
2.  Press the drive between the two brackets until the drive is secured by the clip.
3.  Secure the drive to the front of the computer frame with the two screws you removed in
4.  Connect the power and interface cables to the new drive.
5.
 Replace the front
panel.
6.  Make sure that no cable connections were loosened during the procedure. Arrange cables so that they will not interfere with replacing the power
supply and computer cover.
7.
 Rotate the power supply
back into place.
8.
 Replace the computer
cover.
9.  Plug your computer and devices into their electrical outlets, and turn them on.
"Safety
Instructions."
of the previous procedure.
step 8