DH Lifelabs CAHP-20GC01C Snelstarthandleiding - Pagina 4

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} DH Lifelabs CAHP-20GC01C. DH Lifelabs CAHP-20GC01C 4 pagina's.

Pagina afdrukken

Control Panel

Wi-Fi Indicator

Flashing amber: Attempting to connect

Steady amber: Connection successful

Steady red: Not connected

Connect/disconnect: Short press

Timer

(2H/4H/8H) Set the timer to have

the device turn off automatically

Sleep Mode

Lowest fan speed level that

is ultra-quiet

On/Off

Powers the device on and off

Real-Time Air Quality Indicator Ring

Good

Auto Mode

Blue: Air Quality Good

Yellow: Air Quality Moderate

Red: Air Quality Poor

Fan Speed

(1/2/3) Three fan speeds

Plasma On/Off

Press the icon to toggle the plasma

purification function on or off

Filter Replacement

Indicator

After changing filter, press for

3 seconds to reset the filter life

countdown

Moderate

Poor

Connectivity

Sciaire Mini + HEPA can connect with your smart

device when you download the DH Lifelabs App.

Follow the steps below and/or in the App. Works with

Google Home or Amazon Alexa.

DH Lifelabs App

1. On your smartphone, install DH Lifelabs app and turn your Bluetooth function on.

2. Turn the device on.

3. Open DH Lifelabs app and add the device.

4. When the app indicates, press and hold the Wi-Fi Indicator for 3 seconds.

5. The app should connect to the device over your Wi-Fi network and the Wi-Fi

Indicator will illuminate amber.

To disconnect from the network, press the Wi-Fi Indicator. The device will beep

and the indicator will illuminate red.

Cleaning and Maintenance

Always unplug the device if not in use and while cleaning.

When the device is not used for an extended time, store it

in a cool dry place. Do not store the device where it might

be exposed to excess moisture or direct sunlight. May not

operate effectively in freezing temperatures. Use a dry cloth

to clean the exterior of the device. Do not use any chemicals

or cleaners.

Cleaning the Air Quality Sensor

The inlet for the air quality sensor is located at the back of

the device as shown. The inlet should be cleaned every 2

months using a vacuum or with a cotton swab that has been

lightly moistened with clean water.

GET IT ON

AIR QUALITY SENSOR