Dell E67S Referentiehandleiding - Pagina 10

Blader online of download pdf Referentiehandleiding voor {categorie_naam} Dell E67S. Dell E67S 22 pagina's.

Table 9. NVMe Settings details

Option

NVMe Mode

BIOS NVMe Driver

Boot Settings

You can use the Boot Settings screen to set the boot mode to either BIOS or UEFI. It also enables you to specify the boot

order.

● UEFI: The Unified Extensible Firmware Interface (UEFI) is a new interface between operating systems and platform

firmware. The interface consists of data tables with platform related information, boot and runtime service calls that are

available to the operating system and its loader. The following benefits are available when the Boot Mode is set to UEFI:

○ Support for drive partitions larger than 2 TB.

○ Enhanced security (e.g., UEFI Secure Boot).

○ Faster boot time.

NOTE:

You must use only the UEFI boot mode in order to boot from NVMe drives.

● BIOS: The BIOS Boot Mode is the legacy boot mode. It is maintained for backward compatibility.

To view the Boot Settings screen, power on the system, press F2, and click System Setup Main Menu > System BIOS >

Boot Settings.

Table 10. Boot Settings details

Option

Boot Mode

Boot Sequence Retry

Hard-disk Failover

Generic USB Boot

Hard-disk Drive Placeholder

Clean all Sysprep order and variables When set to None, BIOS will do nothing. When set to Yes, BIOS will delete

UEFI Boot Settings

Pre-operating system management applications

Description

This option sets the NVMe drive mode. If the system contains NVMe drives that you

want to configure in a RAID array, you must set both this field and the Embedded

SATA field on the SATA settings menu to RAID Mode. You may also need to change

the Boot Mode setting to UEFI. The option is set to Non-RAID mode by default.

Dell Qualified NVMe drives always use the UEFINVMe driver built into the Dell EROS.

When this option is set to 'All Drives', the BIOS driver will also be used with any NVMe

drives in the system that has not been qualified by Dell. The option is set to Dell

Qualified Drives by default.

NOTE:

When this option is set to 'All Drives' and non-Dell qualified NVMe drives

are present, you have a configuration that has not been validated which may lead

to unexpected behavior.

Description

Enables you to set the boot mode of the system. If the operating system supports

UEFI, you can set this option to UEFI. Setting this field to BIOS allows compatibility

with non-UEFI operating systems. This option is set to UEFI by default.

CAUTION:

Switching the boot mode may prevent the system from

booting if the operating system is not installed in the same boot mode.

NOTE:

Setting this field to UEFI disables the BIOS Boot Settings menu.

Enables or disables the Boot Sequence Retry feature. If this option is set to

Enabled and the system fails to boot, the system re-attempts the boot sequence

after 30 seconds. This option is set to Enabled by default.

Enables or disables the Hard-disk failover. This option is set to Disabled by default.

Enables or disables the generic USB boot placeholder. This option is set to

Disabled by default.

Enables or disables the Hard-disk drive placeholder. This option is set to Disabled

by default.

variables of SysPrep #### and SysPrepOrder this option is a onetime option, will

reset to none when deleting variables. This setting is only available in UEFI Boot

Mode. This option is set to None by default.

Specifies the UEFI boot sequence. Enables or disables UEFI Boot options.