Dell PowerEdge 2420 Handmatig - Pagina 4

Blader online of download pdf Handmatig voor {categorie_naam} Dell PowerEdge 2420. Dell PowerEdge 2420 9 pagina's. Rack enclosures
Ook voor Dell PowerEdge 2420: Handmatig (20 pagina's), Handmatig (20 pagina's), Handmatig (17 pagina's), Handmatig (12 pagina's), Handmatig (10 pagina's), Handmatig (10 pagina's), Handmatig (9 pagina's), Handmatig (10 pagina's), Handmatig (12 pagina's), Handmatig (11 pagina's), Handmatig (8 pagina's), Technisch handboek (37 pagina's)

Cable Routing Procedures for Dell™ PowerEdge™ R715 Systems

Introduction

This white paper covers recommended cable routing procedures for Dell™ PowerEdge™ R715

systems in the following racks:

•

PowerEdge™ 4820/4220/2420

•

PowerEdge™ 4210/2410

If you are using the optional CMA, following these procedures will allow you to extend the system

from the rack for service without powering down or disconnecting the cables. If you are not using the

CMA, following these procedures will ensure secure attachment and strain relief of the cables behind

the system. For guidelines on how to route cables within the rack, refer to the Dell

Guide for Rack Enclosure

Section 1: Cabling a Dell™ PowerEdge™ R715 With a Cable Management

Arm (CMA)

This section details how to cable a PowerEdge™ R715 system using a CMA. If you are cabling the

system without the optional CMA, refer to Section 2.

Follow the instructions contained in the

the rack. Once installed, use these instructions to install the cables. All illustrations in the following

sections were created using a PowerEdge™ R715 system.

NOTE: PowerEdge™ R715 systems are not compatible with previous generation rails and CMAs.

Attach the CMA tray to the back of the rails as described in the

in the CMA kit. Connect all applicable cables to the rear of the system and verify that all connections

are secure. See Figure 1.

white paper.

Rack Installation Guide

Best Practices

in the rail kit to install the server into

CMA Installation Instructions

provided

Page 2