DH Lifelabs AQUASOLVO ASE-00WH07 Gebruiksaanwijzing - Pagina 7
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} DH Lifelabs AQUASOLVO ASE-00WH07. DH Lifelabs AQUASOLVO ASE-00WH07 9 pagina's. Eco disinfectant generator
Ook voor DH Lifelabs AQUASOLVO ASE-00WH07: Snelstarthandleiding (4 pagina's)
Pagina afdrukken
Troubleshooting
Symptom
Probable Cause/Solution
Base LED does not
Power problem. Check power cord and circuit breaker.
illuminate
Base LED illuminated,
Pitcher is not securely mounted in base; make sure it is seated
but no bubbles in pitcher
properly.
during electrolysis
Base LED illuminated,
Possibly using purified or distilled water; use ordinary tap water.
but bubbles are sparse
Make sure the amounts of salt and vinegar are correct for the
Unit does not operate
concentration being produced.
For any issues not covered here, contact Customer Assistance.
Device Specifications
Model Number
Power Consumption
Input Voltage
Pitcher Capacity
Spray Bottle Capacity
HOCl Recipe
(Low concentration 100ppm)
HOCl Recipe
(High concentration 200ppm)
Material & Finish
Dimensions
Net Weight (without water)
9
9
ASE-00WH07
18 Watts
120 VAC, 60Hz
1000ml/33.81 oz.
150ml/5.07oz. *2
2 scoops ( 2 grams) of non-iodized salt:
1000ml/33.81 oz. of tap water: 4ml/0.14oz. of
5% white vinegar
4 scoops (4 grams) of non-iodized salt:
1000ml/33.81 oz. of tap water: 4ml/0.14oz. of
5% white vinegar
ABS, White
6.6x 6.8x 9 inches (167.4 x 171.7 x 229.7 mm)
1.87lbs (0.85kg)
Cleaning & Maintenance
We recommend not leaving disinfectant in
pitcher or bottles for more than 48 hours.
How to clean:
1. Fill the pitcher with 500ml/16.91oz. of water.
Do not add any salt or vinegar.
2. Press both buttons on
the control panel.
3. Wait 3 minutes.
4. Empty pitcher.
•
Do not leave disinfectant in the bottle for an extended period of time (no more than
48 hours is recommended).
•
When the device won't be used for an extended period of time store it in a cool dry
place. Do not store the device where it might be exposed to excessive moisture or
direct sunlight. The device may not operate effectively in very low temperatures. The
device can be damaged when exposed to sub-freezing temperatures.
•
Use a dry cloth to clean the exterior of the device. Do not use any chemicals or cleaners
•
Do not allow water to accumulate between the pitcher and the base. If the matting
surface of the base is wet, immediately wipe dry with a clean, dry cloth and allow to
thoroughly dry before use.
Do not remove the electrode from the bottom of the pitcher. Avoid any vigorous
•
rubbing or cleaning of the electrodes. If you see white, scaly mineral deposits collecting
on the electrode, add a small amount of vinegar to the pitcher and gently clean it to
remove the scaling.
+
10