Dell PowerEdge 2650 Installatiehandleiding - Pagina 16

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Dell PowerEdge 2650. Dell PowerEdge 2650 20 pagina's. Activating the integrated raid controller
Ook voor Dell PowerEdge 2650: Installatiehandleiding (26 pagina's), Installatiehandleiding (32 pagina's), Informatie-update (14 pagina's), Installatiehandleiding (40 pagina's), Vervangingshandleiding (28 pagina's), Gebruiksaanwijzing (8 pagina's), Handmatig (42 pagina's), Handmatig (15 pagina's), Handmatig (42 pagina's)

Pagina afdrukken
Dell PowerEdge 2650 Installatiehandleiding

Installing the System in the Rack

CAUTION: Due to the size and weight of the system, never attempt to install the
system by yourself.
NOTE: The procedure for installing a system into a rack is identical for flush-mount
and center-mount slide assemblies.
Pull the slides out to their fully extended position.
1
CAUTION: Because of the size and weight of the system, never attempt to install
the system in the slide assemblies by yourself.
Lift the system into position (see Figure 1-6).
2
Place one hand on the front-bottom of the system and the other hand on the back-
3
bottom of the system.
Tilt the back of the system down while aligning the back shoulder screws on the sides
4
of the system with the back slots on the slide assemblies.
Engage the back shoulder screws into their slots.
5
Lower the front of the system, and engage the front and middle shoulder screws in
6
their slots (the middle slot is behind the yellow system release latch) (see Figure 1-6).
When all shoulder screws are properly seated, the yellow latch on each slide assembly
clicks and locks the system into the slide assembly.
Press up on the green slide release latch at the side of each slide to slide the system
7
completely into the rack (see Figure 1-6).
Push in and turn the captive thumbscrews on each side of the front chassis panel to
8
secure the system to the rack.
NOTE: Use the yellow system release latch whenever you wish to remove the system
from the slide assemblies.

Installing the Cable-Management Arm

NOTICE: The cable-management arm can only be installed on the right side of the
rack cabinet (as viewed from the back).
To install the cable-management arm on the system, perform the following steps:
Facing the back of the rack cabinet, locate the latch on the end of the slide assembly.
1
Push the tab on the back end of the cable-management arm into the latch on the end
2
of the slide assembly (see Figure 1-7).
The latch clicks when locked.
1-12
2-Pos t Rack Installation