Dell PowerEdge 4400 Installatiehandleiding - Pagina 6

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Dell PowerEdge 4400. Dell PowerEdge 4400 36 pagina's. Wake-on-lan (wol) support on dell servers
Ook voor Dell PowerEdge 4400: Installatiehandleiding (42 pagina's), Installatiehandleiding (20 pagina's), Installatiehandleiding (28 pagina's), Installatie rek (37 pagina's), Handleiding bijwerken (8 pagina's), Informatie-update (8 pagina's), Gebruikershandleiding (42 pagina's), Installatie rek (34 pagina's), Hardware installatiehandleiding (40 pagina's), Handmatig (15 pagina's)

Pagina afdrukken
Dell PowerEdge 4400 Installatiehandleiding
1-2
Dell PowerEdge Systems — Installing the External Drive Bay
Installing a SCSI Hard-Disk Drive in the External

Drive Bay

To install a SCSI hard-disk drive in the external drive bay, use the following procedure:
1.
Locate the four mounting holes on each side of the external drive bay. Align a rail
bracket with the set of holes that, when the rail is installed, places the rail closer
to the front of the external drive bay.
2.
Secure a rail bracket to the left and right sides of the external drive bay using the
screws provided (see Figure 1-1).
3.
Attach the hard-disk drive to the drive carrier.
a.
With the drive carrier laying flat, place the hard-disk drive right-side up on the
carrier with the front of the drive directly behind the carrier handle and the
drive connector on the end of the carrier.
b.
Secure the hard-disk drive to the drive carrier with four screws inserted
through the sides of the carrier.
4.
Align the edge of the drive carrier with the notches in the drive bay assembly and
slide the carrier into the assembly as shown in Figure 1-1.
external drive-bay
assembly with rail
brackets attached
SCSI hard-disk
drive in a drive
carrier
flush-mount
screw
NOTE: The shroud is removed from the drive bay for clarity.
Figure 1-1. Installing the External Drive-Bay and Hard-Disk Drive
Carrier
5.
Close the drive carrier handle to lock the drive in place.
6.
Repeat steps 3 through 5 to install a second drive in the assembly.
drive carrier
handle
drive-carrier
locking bar