Dell PowerEdge 860 Servicehandleiding - Pagina 14

Blader online of download pdf Servicehandleiding voor {categorie_naam} Dell PowerEdge 860. Dell PowerEdge 860 37 pagina's. Sas/raid controller installation
Ook voor Dell PowerEdge 860: Informatie-update (14 pagina's), Installatiehandleiding (28 pagina's), Handleiding voor installatie-instructies (7 pagina's)

display cable

9. Remove the two screws from either side of the display hinges.

10. Lift and remove the display assembly.

display hinge screw (4)

display cable

Replacing the Display Assembly

CAUTION:

Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

1. Place the display assembly in place and replace the two screws on each side of the display hinges.

2. Re-route and connect the display cable to the connector on the system board.

3. Carefully route the WLAN antenna cables into their routing guides on the palm rest and through the computer base.

4. Replace the keyboard (see Keyboard).

5. Replace the two screws at the back of the computer.

6. Turn the computer over and carefully route the WLAN card antenna cables through their routing guides and connect them to the WLAN card.

7. Reconnect the WLAN card if applicable (see

8. Replace the memory modules (see

9. Slide the battery into the battery bay, until it clicks in place.

antenna cables

Replacing the WLAN

Card).

Replacing the Memory

Module(s)).