Dell PowerEdge R610 Handmatig - Pagina 9

Blader online of download pdf Handmatig voor {categorie_naam} Dell PowerEdge R610. Dell PowerEdge R610 10 pagina's. Poweredge series
Ook voor Dell PowerEdge R610: Documentatie bijwerken (14 pagina's), Handleiding bijwerken (32 pagina's), Informatie-update (14 pagina's), Informatie-update (38 pagina's), Handleiding bijwerken (44 pagina's), Installatie-instructies (2 pagina's), Instructies voor installatie van hardware (2 pagina's), Handleiding bijwerken (14 pagina's), Portfolio Handleiding (27 pagina's), Gegevensblad (2 pagina's), Onderhoud en probleemoplossing (24 pagina's)

Cabling the Dell™ PowerEdge™ R610

Replacing a Power Supply on a PowerEdge R610 with CMA

1. Remove the tray from under the CMA as described in the CMA Installation Instructions provided with the CMA

kit.

2. Swing the CMA into the service position.

3. Disconnect the power cord from the power supply and disengage the strain relief.

4. Remove and replace the power supply

If the CMA is attached to the left side, both power supplies can be removed without disconnecting

the CMA.

b. If the CMA is attached to the right side and the inner power supply needs to be replaced, the CMA

does not need to be disconnected.

If the CMA is attached to the right side and the outer power supply needs to be replaced, the inner

CMA attachment housing will need to be disconnected. While supporting the CMA with one hand,

remove and replace the power supply with the other hand as shown in Figure 9.

Figure 9: Replacing Outer Power Supply

Inner CMA attachment housing has

been disconnected

5. Plug in the power cord.

6. Re‐engage the strain relief.

7. Return the CMA to the closed (retracted) position.

Page 7