Dell PowerEdge R620 Handmatig - Pagina 5

Blader online of download pdf Handmatig voor {categorie_naam} Dell PowerEdge R620. Dell PowerEdge R620 11 pagina's. Poweredge series
Ook voor Dell PowerEdge R620: Aan de slag handleiding (12 pagina's), Installatie-instructies (2 pagina's), Installatie-instructies (2 pagina's), Portfolio Handleiding (27 pagina's), Aan de slag handleiding (10 pagina's), Handleiding voor installatie, onderhoud en probleemoplossing (48 pagina's)

Cable Routing Procedures for Dell PowerEdge R620 Systems

1.2. Routing the power cables through the strain reliefs

After you have installed the tray and cables, route the power cables through the strain reliefs located

on the power supply handles as shown in Figure 2.

Figure 2.

Routing power cables through the strain reliefs

The CMA can be installed on either the rear right or rear left side of the rails as described in the CMA

Installation Instructions. Mounting the CMA on the side that is opposite of the power supplies (left-side

mount) is recommended; otherwise, the CMA must be partially disconnected in order to remove the

outer power supply. Refer to Section 2 for details on power supply replacement.

NOTE: If you are installing fiber-optic cables in the CMA, a cable bend radius of at least 1 inch must be

maintained throughout the length of the cable. It is recommended that fiber-optic cables be routed on

the exterior of the cable bundle to increase the bend radius of the fiber-optic cables through the CMA.

Additionally, a large amount of slack at the entrance and exit of the CMA is recommended.

1.3.1. Installing the inner CMA attachment bracket

As described in the CMA Installation Instructions, locate and attach the appropriate inner CMA

attachment bracket based on which side you wish to mount the CMA. Use the bracket marked "A" for

mounting the CMA on the left side, and the bracket marked "B" for mounting on the right side. See

Figure 3.

Attaching the inner CMA attachment bracket