EarthCore PET-30P Gebruikershandleiding - Pagina 8

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} EarthCore PET-30P. EarthCore PET-30P 18 pagina's.

Pagina afdrukken

The ISO-FLAMES gas log set must be installed by a qualiﬁ ed professional service technician. Instructions

must be followed carefully to ensure proper performance and full beneﬁ t from the gas log set. Check to be

sure the log set is designed and labeled for the type of gas (natural or propane gas) supplied to the

ﬁ replace. Fireplace ﬂ oor must be level, clean, and smooth.

WARNING: Failure to position the parts in accordance with these diagrams or failure to use only

parts speciﬁ cally approved with this appliance may result in property damage or

personal injury.

1. MAKE SURE THE FIREPLACE GAS SUPPLY IS

TURNED OFF.

2. Place the burner system in the ﬁ replace. Center the

burner toward the rear of the ﬁ replace. (Reference Fig.

8-2 for orientation.)

3. Locate the gas-supply stub inside the ﬁ replace and

remove the cap, if attached (see Fig. 8-1).

4. Use pipe compound resistant to all gases or Teﬂ on

tape to attach the supplied elbow to the gas-supply

stub. Then attach the ﬂ ex connector (coming off of the

burner system) to the elbow (see Fig. 8-1).

5. LEAK TEST: Turn on the ﬁ replace gas supply, and test

at all connections for leaks using the appropriate soapy

water solution. If bubbles appear, a leak is present. Turn

off the gas and tighten at all connections. Repeat until

no leaks are present. If a leak persists, turn off the gas

supply and contact the local gas company or dealer.

NEVER USE A FLAME TO CHECK FOR LEAKS.

6. Place the remote receiver box at the right front corner

of the ﬁ replace. Be sure to run its wire in between the

two grate legs on the right side of the burner system,

and that the wire remains away from the burner system

and its ﬂ ame during operation. (See Fig. 8-2.)

Note: Alternately; the box can be placed at the rear

right corner of the burner system. Be sure

to place its wire towards the back so that it

remains away from the burner system and its

ﬂ ame during operation. (See Fig. 8-3.)

If optional wall switch was purchased separately; refer

to the instructions supplied with the wall switch for

installation.

For all valves, the air MUST be purged from the gas line before the pilot will light and burn properly. The

time needed to purge will depend on the length of the gas line to the unit and the amount of time since

the unit or gas line was last used. It may take several minutes before all the air is purged and the pilot

will light and burn properly. Reference the LIGHTING INSTRUCTIONS section in this manual.

BURNER INSTALLATION

IMPORTANT

Gas-supply stub

Fig. 8-1 Connect gas supply

Fig. 8-2 Remote receiver box location

Fig. 8-3 Alternate receiver box location

Flex connector

Elbow