Dell 2407WFP-HC - UltraSharp - 24" LCD Monitor Gebruikershandleiding - Pagina 34
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Dell 2407WFP-HC - UltraSharp - 24" LCD Monitor. Dell 2407WFP-HC - UltraSharp - 24" LCD Monitor 50 pagina's. Flat panel monitor
Ook voor Dell 2407WFP-HC - UltraSharp - 24" LCD Monitor: Installatiehandleiding (2 pagina's), Brochure & specificaties (3 pagina's)
Pagina afdrukken
B
PIP / PBP Select
C
OSD Menu / Select
D
Brightness/Contrast Hot Key
D
,E
Down (-) and Up (+)
E
Auto Adjust
F
Power button
(with power light indicator)
Using the OSD
Accessing the Menu System
NOTE:
If you change the settings and then either proceed to another menu, or exit the OSD menu, the monitor automatically saves those changes. The changes are also saved if you
settings and then wait for the OSD menu to disappear.
1. Push the MENU button to launch the OSD menu and display the main menu.
Main Menu for Analog (VGA) Input
Or
Main Menu for non Analog (non VGA) Input
Use this button to activate PIP (Picture-in-Picture) / PBP (Picture-by-Picture) modes adjustment.
Pressing this button continually cycles the
messages corresponding to the mode selected.
→
The MENU button is used to launch the on-screen display(OSD) and select the OSD Menu. See
Use this button for direct access to the "Brightness" and "Contrast" control menu.
Use these buttons for navigating and adjusting the slider-bar(decrease/increase ranges) controls in the OSD.
Use this button to activate automatic setup and adjust menu. The following dialog appears on a black screen as the monitor self
to the current input:
Auto Adjustment allows the monitor to self-adjust to the incoming video signal. After using Auto Adjustment, you can further tune your
monitor by using the Pixel Clock (Coarse) and Phase (Fine) controls under Image Settings.
NOTE: Auto Adjust will not occur if you press the button while there are no active video input signals or
attached cables.
The green LED indicates the monitor is on and fully functional. An amber LED indicates DPMS power save mode.
The Power button turns the monitor on and off.
monitor through the following modes : OFF- ->PIP- ->PBP. You will see the following
→
Auto Adjust In Progress