Dell D1626HT - UltraScan 1600HS - 21" CRT Display Servicehandleiding - Pagina 9

Blader online of download pdf Servicehandleiding voor {categorie_naam} Dell D1626HT - UltraScan 1600HS - 21" CRT Display. Dell D1626HT - UltraScan 1600HS - 21" CRT Display 48 pagina's. Color monitor
Ook voor Dell D1626HT - UltraScan 1600HS - 21" CRT Display: Servicehandleiding (48 pagina's)

Pagina afdrukken

4 Using the ZOOM OSD

You can enlarge or reduce the picture size using the ZOOM

OSD.

This setting is stored in memory for the current input signal.

1 Press the MENU button to display the MENU OSD.

2 Highlight the ZOOM OSD using the BRIGHTNESS and

CONTRAST buttons and press the MENU button again.

3 Press the > (CONTRAST) ? // buttons to enlarge or

reduce the picture size.

4 Press the MENU button once to return to the MENU OSD,

or press it twice to return to normal viewing.

Note

You can enlarge or reduce the picture size until either the

horizontal or vertical size reaches its maximum or minimum

value.

Customizing Your Monitor

Getting Started

5 Using the OPTION OSD

You can manually degauss (demagnetize) the CRT, select the

input signal, move the OSD position, set the Power Saving

delay time, and lock the user controls using the OPTION OSD.

1 Press the MENU button to display the MENU OSD.

2 Highlight the OPTION OSD using the BRIGHTNESS and

CONTRAST buttons and press the MENU button again.

3 Press the ¨ (BRIGHTNESS) ./> buttons to select the

desired adjustment item.

4 Press the > (CONTRAST) ? // buttons to activate the

manual degauss, select the input signal, move the OSD

position, change the Power Saving delay time or lock the

user controls.

5 Press the MENU button once to return to the MENU OSD,

or press it twice to return to normal viewing.

Degauss: If a second degauss cycle is needed, allow a minimum

interval of 20 minutes for the best result.

Input Signal Selection: Select the desired input signal when

two computers are connected.

OSD Position Change: To change the OSD position, press the

¨ (BRIGHTNESS) ./> buttons to select the direction

(horizontal or vertical), then press the > (CONTRAST)

?// buttons to move the OSD in the selected direction.

Power Saving Delay Time: The monitor enters Power Saving

mode after the selected time elapses. If you select "OFF," the

monitor does not go into Power Saving mode.

User Control Lock: Once you select "ON" to lock the user

controls, you cannot select any item except "EXIT" and

"OPTION" in the MENU OSD. If you try to access any other

OSD, the H mark appears on the screen.

To cancel the Control Lock: Repeat the above procedure and

set Control Lock to "OFF."

C s

C t