ensto LISTA7-BT Installatie- en bedieningshandleiding - Pagina 15
Blader online of download pdf Installatie- en bedieningshandleiding voor {categorie_naam} ensto LISTA7-BT. ensto LISTA7-BT 20 pagina's.
Pagina afdrukken
Temperature Change with Calendar, Boost and Vacation
•
With this application you can change the setting temperature adjusted with the adjustment knob C
on the heater.
•
The change may be either a rise or a drop in temperature.
•
The blue LED indicator E is on when the temperature change is connected.
•
Press the
button on home display to enter the editing mode.
•
"Calendar" is intended for weekly reoccuring events. For example, on weekdays you can drop the tem-
perature overnight and while you are away, during weekends you may want to drop the temperature
overnight. Note! When making settings for overnight, the night must be in two sections.
•
"Boost" is intended for a temporary temperature change. For example, after a shower you can raise
the temperature in the bathroom, so that the floor will dry faster.
•
"Vacation" is intended for long-term changes in temperature, e.g for a weekend break or an annual
holiday.
•
The "Calendar", "Boost" and "Vacation" buttons are on / off buttons. When the temperature change is
activated, the "Calendar" and "Vacation" buttons are green, the "Boost" button is orange.
•
When the function "Adaptive temperature change" is active, the thermostat will advance the heating,
so that the desired temperature has been reached at the scheduled time. By default, the function is
on.
Resetting the Factory Settings
•
Press the Bluetooth button on the heater, figure 5.3 .
•
After 7 seconds, the blue LED indicator starts to blink quickly.
•
Paired devices, consumption information and calendar settings are removed.
Battery
•
The purpose of the battery is to maintain the time during power cuts. If the clock does not keep correct
time, the battery must be replaced. The battery change interval is several years and is usage depend-
ent.
The battery may only be replaced by a skilled or instructed person.
Disconnect the power supply before replacing the battery.
•
Remove the four fastening screws on the thermostat.
•
Pull the thermostat out.
•
The battery is located on the thermostat circuit card, figure 6.
•
Replace the battery with same type of battery as the original, CR1632.
•
Put the thermostat in place and secure it with the fastening screws.
•
Dispose of the empty battery according to local recycling guidelines.
Environmental Aspects
The heater's cardboard packing is suitable for recycling.
When the heater is at the end of the life cycle, it must be disposed of properly according to local
recycling guidelines.
Warranty
The warranty period for Ensto Tupa heaters is 5 years from the date of purchase but no longer than 6 years
from the date of manufacture. The manufacture date is located on the rating label.
Warranty terms, see the product card
Declaration of Conformity
Hereby, Ensto Finland Oy declares that the Tupa heaters are in compliance with Directive 2014/53/EU. The
full text of the EU declaration of conformity is available at the following internet address: www.ensto.com.
www.ensto.com.
RAK120 / © Ensto 2018
15