Dell EMC Integrated Data Protection Appliance DP4400 Hardware installatiehandleiding - Pagina 9
Blader online of download pdf Hardware installatiehandleiding voor {categorie_naam} Dell EMC Integrated Data Protection Appliance DP4400. Dell EMC Integrated Data Protection Appliance DP4400 18 pagina's. Emc integrated data protection appliance
Pagina afdrukken
- 1. Table of Contents
- 2. Installation Overview
- 3. Prepare the Site and Unpack the System
- 4. Install Network Validation Tool
- 5. Install the Rails
- 6. Secure the Rails to the Cabinet
- 7. Install the System in the Cabinet
- 8. Install the Bezel
- 9. Connect the System to the Network
- 10. Connect the Power Cables and Power on
- 11. Configure Idrac
- 12. Installing the Dataprotection-ACM Pre-Installation Patch
- 13. Launch the Appliance Configuration Manager
- 14. Additional Resources
3. Rotate the system downward until all the rail standoffs are seated in the J-slots.
Figure 5 Install the system in the rails
4. Push the system inward until the lock levers click into place.
5. Pull the blue slide release lock tabs forward on both rails and slide the system
into the cabinet. The slam latches will engage to secure the system in the
cabinet.
Note
Ensure that the inner rail slides completely into the middle rail. The middle rail
locks if the inner rail is not fully engaged.
Install the system in the cabinet
9