Dell PowerVault 725N Firmware bijwerken - Pagina 11

Blader online of download pdf Firmware bijwerken voor {categorie_naam} Dell PowerVault 725N. Dell PowerVault 725N 12 pagina's. Nas systems with software raid
Ook voor Dell PowerVault 725N: Handleiding bijwerken (10 pagina's), Informatie-update (28 pagina's)

Pagina afdrukken
Dell PowerVault 725N Firmware bijwerken
If a DHCP server is not on the network, enable the Kick-Start utility and manually
13
create the DHCP settings. Otherwise, if a DHCP server is on the network, go to
step 14.
NOTE: If you do not have a DHCP server, you must perform the following steps to create
the DHCP settings for the NAS server.
Turn on your NAS system.
a
Click the Start button and point to Programs→ Dell Reinstallation Console→
b
Dell OpenManage Kick-Start.
When asked if you want to run the program, click Yes.
c
At the bottom of the Dell OpenManage Kick-Start window, click Setup.
d
Click Add.
e
In the Add Scope window, enter the IP network and subnet mask information.
f
If you are not sure about the information you need to enter in these fields, contact
your network administrator.
NOTE: If you run the Kick-Start utility in a non-DHCP environment, you must enter a
gateway IP address.
Click OK to close the Add Scope window.
g
Click Interfaces for DHCP Server so that it is checked.
h
Click OK to close the Setup window.
i
Click Enabled at the bottom of the Dell OpenManage Kick-Start window to start
j
the integrated DHCP server.
Start the Intel PXE server and verify that the services are running.
14
Click the Start button and point to Programs→ Dell Reinstallation Console→
a
Intel PXE Server.
In the PXE Configuration Utility window, right-click the server name,
b
PV725REC, and then select Start/Stop Services.
Verify that the proxy DHCP/Boot PXE and M/TFTP services are installed and
c
running correctly by selecting Stop and then selecting Start.
If the services are running, the indicator displays Running after you click Start
and displays Stopped after you click Stop.
Click OK.
d
If it is off, turn on your NAS system. If it is already on, reboot your system.
15
Upgr ading Yo ur 39160 SC SI Card Fir mware
1-9