Dell SC180 Gebruikershandleiding - Pagina 29

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Dell SC180. Dell SC180 39 pagina's. Storage center
Ook voor Dell SC180: Gebruikershandleiding (37 pagina's)

Pagina afdrukken

NOTE: It is possible for a drive to appear seated but not be fully locked into position,

eventually causing it to dislodge itself. After installing a drive, check the release button in the

center of the DDIC. If the drive is NOT fully locked into position, a yellow line will be visible

underneath the arrow button. If the yellow line is visible, remove the drive and re-install it.

CAUTION: If the DDIC fails to latch, do not use it and request a replacement from Dell

Technical Support Services. If a faulty DDIC unlatches within a closed drawer, it can make

the drawer unable to be opened.

Close the drawer.

a. Locate the two lock-release buttons situated midway along the runners on each side of the

drawer.

b. Press the lock-release buttons inward and use your body to push the drawer toward the chassis

until the locks disengage.

c. Place your hands on the front bezel and continue to push the drawer inward until the bezel is

flush with the chassis and the front drawer locks engage.

Figure 21. Closing the Drawer

WARNING: Keep fingers clear of the chassis as the drawer is closed.

In the Dell Storage Client, make sure that the replacement hard drive is recognized and shown as up

and running. If the Dell Storage Client informs you that there are unassigned hard drives, see the Dell

Storage Manager Client Administrator's Guide for instructions on managing unassigned hard drives.

NOTE: Allow several seconds for the enclosure to recognize the hard drive and determine its

status. When the hard drive is functioning properly, the indicator turns green in the Dell Storage

Client and the LED on the DDIC is off.

Next steps

Use SupportAssist to send diagnostic data to Dell Technical Support Services.

Replacing SC180 Expansion Enclosure Components