Dell SC9000 Aan de slag handleiding - Pagina 3

Blader online of download pdf Aan de slag handleiding voor {categorie_naam} Dell SC9000. Dell SC9000 10 pagina's.
Ook voor Dell SC9000: Gebruikershandleiding (18 pagina's)

Pagina afdrukken
Dell SC9000 Aan de slag handleiding

Setting Up the Storage System

Consider the following best practices before setting up your SC9000 storage system.
•
Dell recommends that you use a dedicated SAN network for data transmission when using a Fibre
Channel or iSCSI storage system.
•
Always configure redundant data paths to provide alternate paths to and from the host server should
one of the data paths become disabled.
•
Before connecting any cables between the storage system and host server or expansion enclosure,
physically label each port and connector.
•
Always follow proper power-up and power-down procedures when cycling power across the
network. Verify that critical network components are on separate power circuits.
NOTE: This product is intended for restricted access locations, such as a dedicated equipment
room or equipment closet.
WARNING: If installed in a closed or multi-unit rack assembly, the operating ambient
temperature of the rack environment may be greater than room ambient temperature. Therefore,
consideration should be given to installing the equipment in an environment compatible with the
maximum ambient temperature (Tma) specified by the manufacturer.

Safety Warnings

The following information only applies to Fibre Channel storage systems.
Laser Radiation for Fibre Channel Storage Systems
The unit is certified in the U.S. to conform to the requirements of DHHS 21 CFR, chapter 1 Subchapter J
for Class I (1) laser products, and elsewhere is certified as a Class I laser product conforming to the
requirements of IEC 60825-1:2007.
Class I laser products are not considered to be hazardous. The laser system and unit are designed so
there is never any human access to laser radiation above a Class I level during normal operation, user
maintenance or prescribed service condition.

Locating Your Service Tag

Your storage system is identified by a unique Service Tag and Express Service Code.
The Service Tag and Express Service Code are found on the front of the system by pulling out the
information tag. Alternatively, the information may be on a sticker on the back of the storage system
chassis. This information is used by Dell to route support calls to the appropriate personnel.
CAUTION: Class I laser radiation when open, avoid exposure to beam.
WARNING: Laser radiation, avoid direct exposure to beam.
3