Dell VxRail E660 Installatie- en onderhoudshandleiding - Pagina 30
Blader online of download pdf Installatie- en onderhoudshandleiding voor {categorie_naam} Dell VxRail E660. Dell VxRail E660 32 pagina's.
Ook voor Dell VxRail E660: Installatie- en onderhoudshandleiding (32 pagina's)
Pagina afdrukken
Table 3. NIC indicator codes (continued)
NIC indicator codes
Link indicator is amber, and activity indicator is blinking
green.
Link indicator is green, and activity indicator is off.
Link indicator is amber, and activity indicator is off.
Link indicator is blinking green, and activity is off.
Power supply unit indicator codes
AC power supply units (PSUs) have an illuminated translucent handle that serves as an indicator. The indicator shows if power is
present or if a power fault has occurred.
1. AC PSU handle
2. Socket
3. Release latch
Power indicator codes
Green
Blinking amber
Not powered on
Blinking green
Blinking green and powers off
30
System diagnostics and indicator codes
Condition
Indicates that the NIC is connected to a valid network at less than its
maximum port speed, and data is being sent or received.
Indicates that the NIC is connected to a valid network at its maximum
port speed, and data is not being sent or received.
Indicates that the NIC is connected to a valid network at less than its
maximum port speed, and data is not being sent or received.
Indicates that the NIC identity is enabled through the NIC
configuration utility.
Condition
Indicates that a valid power source is connected to the PSU
and the PSU is operational.
Indicates an issue with the PSU.
Indicates that the power is not connected to the PSU.
Indicates that the firmware of the PSU is being updated.
CAUTION:
Do not disconnect the power cord or
unplug the PSU when updating firmware. If firmware
update is interrupted, the PSUs will not function.
When hot-plugging a PSU, it blinks green five times at a rate
of 4 Hz and powers off. This indicates a PSU mismatch due to
efficiency, feature set, health status, or supported voltage.
CAUTION:
If two PSUs are installed, both the PSUs
must have the same type of label; for example,
Extended Power Performance (EPP) label. Mixing
PSUs from previous generations of PowerEdge
servers is not supported, even if the PSUs have the
same power rating. This results in a PSU mismatch
condition or failure to power on the system.