Dell Force10 S4810P Snelstarthandleiding - Pagina 9

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Dell Force10 S4810P. Dell Force10 S4810P 27 pagina's. Quick start guide

NOTE: Coat the one-hole lug with an anti-oxidant compound prior to crimping.

Bring any un-plated mating surfaces to a shiny finish, and coat with an anti-oxidant

prior to mating. Plated mating surfaces must be clean and free from contamination.

Step

Task

Take the (1) M4x0.7 screw from the package.

Cut cable to desired length. Cable length must facilitate the proper

operation of fault interrupt circuits. Dell Force10 recommends using the

shortest cable route allowable.

Attach the one-hole lug to the chassis as shown, using the supplied

screw with captive internal tooth lock washer. The screw should be

torqued to 20 in-lbs.

Lug Hole

Ground

Screw

Attach the other end of the ground cable to a suitable ground point. The

rack installation ears are not a suitable grounding point.

Install the SFP+ QSFP+ Optics

The S4810 has 48 SFP+ optical ports and 4 QSFP+ optical ports. For supported

optics, refer to http://www.force10networks.com/products/specifications.asp.

CAUTION: Electrostatic discharge (ESD) damage can occur if components

are mishandled. Always wear an ESD-preventive wrist or heel ground strap

when handling the S4810 and its components.

WARNING: Follow all warning labels when working with optical fibers.

Always wear eye protection when working with optical fibers. Never look

directly into the end of a terminated or unterminated fiber or connector as it

may cause eye damage.

Step

Task

Position the optic so it is in the correct position. (The optic has a key that

prevents it from being inserted incorrectly.

Installing the Hardware