Dell N1500 Series Instructie voor het upgraden van firmware - Pagina 14
Blader online of download pdf Instructie voor het upgraden van firmware voor {categorie_naam} Dell N1500 Series. Dell N1500 Series 17 pagina's. Emcnetworking switches
Pagina afdrukken
- 1. Table of Contents
- 2. Introduction
- 3. Global Support
- 4. Firmware Upgrade Overview
- 5. Firmware Downgrade Overview
- 6. How to Access Serial Console on Dell EMC Networking N1500 Series Switches
- 7. Upgrade Example of Dell EMC Networking N1500 Series Switches
- 8. Upgrade Stack of Dell EMC Networking N1500 Series Switches
- 9. Switch Recovery Procedure
- 10. Switch Recovery Example
- 11. End of Document
Upgrade Dell EMC Networking N1500 Series Switches
Boot Main Menu
==============
1 - Start Operational Code
2 - Select Baud Rate
3 - Retrieve Logs
4 - Load New Operational Code
5 - Display Operational Code Details
9 - Reboot
10 - Restore Configuration to Factory Defaults
11 - Activate Backup Image
12 - Start Password Recovery
Download the firmware to the switch using TFTP (Select option
4.
if firmware is already loaded on switch.
Boot Main Menu
==============
1 - Start Operational Code
2 - Select Baud Rate
3 - Retrieve Logs
4 - Load New Operational Code
5 - Display Operational Code Details
9 - Reboot
10 - Restore Configuration to Factory Defaults
11 - Activate Backup Image
12 - Start Password Recovery
Enter Choice# 4
Creating tmpfs filesystem on /mnt/download for download...done.
Current Active Image# /dev/mtd7
Which Image to Update Active (/dev/mtd7) OR Back-Up (/dev/mtd6)? Select (A/B): A
You selected to update Active Image /dev/mtd7...
Select Mode of Transfer (Press T/X/Y/Z for TFTP/XMODEM/YMODEM/ZMODEM) []:T
Please ensure TFTP server is running to begin Transfer...
Enter Server IP
Enter Host IP []:10.10.10.224
Enter Host Subnet Mask [255.255.255.0]:255.255.0.0
Enter Gateway IP []:10.10.10.254
Enter Filename []:N1500v6.5.2.9.stk
Do you want to continue? Press(Y/N):
Bringing up eth0 interface...done.
Adding default gateway 10.10.10.254 to the Routing Table...done.
Erasing /dev/mtd7!!!
Erasing 128 Kibyte @ 17e0000 -- 99 % complete.
Updating code file...done.
Code Update Instructions Found!
Critical components modified on Active Partition -- System Reboot Recommended!
Reboot? (Y/N): y
Rebooting...
starting pid 11
syncing filesystems....This may take a few moments
Rebooting system!
Reference platform resetting ...
starting pid 17Rebooting system!
[]:10.10.10.200
4 - Load new operational code).
y
Page 12
Skip this step