Dell N2000 Series Handmatig - Pagina 9

Blader online of download pdf Handmatig voor {categorie_naam} Dell N2000 Series. Dell N2000 Series 17 pagina's. Switch dell networking n2000 series
Ook voor Dell N2000 Series: Firmware-upgrade (21 pagina's)

Pagina afdrukken
Dell N2000 Series Handmatig
console(config-telnet)#exit
console(config)#ip http authentication local
console(config)#username admin password yourpassword privilege 15
console(config)#enable password yourpassword
2.5

Enable iSCSI optimization feature

This feature, enabled by default, is activated only when EqualLogic arrays are detected, however, Dell
recommends manually configuring these steps too. This feature, when enabled automatically, performs
the following:
Configures jumbo frames to 9216 on all ports.
Disables unicast storm.
Enables spanning tree portfast on ports connected to EqualLogic arrays.
Configures flow control on all ports.
Note: Spanning tree portfast must be manually configured for host facing ports. Refer to Section 2.8.
console#configure
console(config)#iscsi enable
Enabling iSCSI Optimization will enable Flow Control which may cause all the
interfaces to temporarily go down.
Are you sure you want to continue? (y/n) y
console(config)#exit
2.6

Enable flow control

Note: If iSCSI optimization is enabled, flow control is automatically configured on all switch ports upon
detection of an EqualLogic Array. Dell recommends also manually configuring this step.
console#configure
console(config)#flowcontrol receive on
This operation may take a few minutes.
Management interfaces will not be available during this time.
Are you sure you want to continue? (y/n)y
console(config)#exit
9
SCG1015
Dell Networking N2000 Series Configuration Guide