Dell Networking N2024P Installatiehandleiding - Pagina 11

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Dell Networking N2024P. Dell Networking N2024P 49 pagina's.
Ook voor Dell Networking N2024P: Firmware-upgrade (21 pagina's)

Dell Networking N2024P Installatiehandleiding
You can mount the N20xx Series switches in a standard 48.26 cm (19-inch) rack or placed on a flat surface.
Make sure that the installation location meets the following site requirements:
Power — The switch is installed near an easily accessible 100–240 VAC, 50–60 Hz outlet.
Clearance — There is adequate front and rear clearance for operator access. Allow clearance for cabling, power connections, and
ventilation.
Cabling — The cabling is routed to avoid sources of electrical noise such as radio transmitters, broadcast amplifiers, power lines, and
fluorescent lighting fixtures.
Ambient Temperature — The ambient switch operating temperature range is 0 to 45ºC (32 to 113ºF) at a relative humidity of up to 95
percent, non-condensing.
NOTE:
Decrease the maximum temperature by 1°C (1.8°F) per 300 m (985 ft.) above 900m (2955 ft.).
Relative Humidity — The operating relative humidity is 8% to 85% (noncondensing) with a maximum humidity gradation of 10% per
hour.
Topics:

Unpacking the N20xx Switch

Rack Mounting an N20xx Switch
Stacking on N20xx Series Switches
Unpacking the N20xx Switch
Package Contents
When unpacking each switch, make sure that the following items are included:
One Dell Networking switch
One RJ-45 to DB-9 female cable
One rack-mount kit (N20xx) for rack installation, two mounting brackets, bolts, and cage nuts
One set of self-adhesive rubber pads for the free-standing switch (four pads are included)
Unpacking Steps
NOTE:
Before unpacking the switch, inspect the container and immediately report any evidence of damage.
1
Place the container on a clean, flat surface and cut all straps securing the container.
2
Open the container or remove the container top.
3
Carefully remove the switch from the container and place it on a secure and clean surface.
4
Remove all packing material.
5
Inspect the product and accessories for damage.
10

N20xx Series Installation

N20xx Series Installation
3