Dell PowerConnect 5500 Series Handleiding voor snelle installatie - Pagina 6

Blader online of download pdf Handleiding voor snelle installatie voor {categorie_naam} Dell PowerConnect 5500 Series. Dell PowerConnect 5500 Series 17 pagina's. Networking mobility starter kit

Pagina afdrukken
Dell Networking Mobility Starter Kit – Quick Setup Guide
Figure 1 PowerConnect 5524P Switch Chassis

Configuring the PowerConnect 5500 Series PoE Switch

After the switch is installed on a flat surface or rack and connected to a power supply, we are ready to
begin the configuration.
1. Connect the switch to the terminal and boot the unit. The boot process runs for approximately
40-45 seconds. When the boot process completes, the following LEDs are lit, as shown in the
figure below.
•
Power
•
Status
•
Fan (should be green)
NOTE: For more information on connecting the switch to a terminal, see "Connecting the
Switch to the Terminal" section in the Dell PowerConnect 5500 Series Getting Started Guide.
Figure 2 PowerConnect 5524P LEDs
2. Obtain the following information from the network administrator:
•
Username and password for switch admin access
•
The IP address assigned to the VLAN 1 interface through which the switch is to be
managed (by default, every external and internal port is a member of the VLAN 1)
•
The IP subnet mask for the network
•
The default gateway (next hop router) IP address for configuring the default route
•
SNMP Community String and SNMP Management System IP address (optional)
6