Allied Telesis AT-AR024 ASYN4 Installatiehandleiding - Pagina 9

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Allied Telesis AT-AR024 ASYN4. Allied Telesis AT-AR024 ASYN4 13 pagina's. Port interface card
Ook voor Allied Telesis AT-AR024 ASYN4: Installatiehandleiding (13 pagina's), Handleiding voor snelle installatie (10 pagina's), Installatie- en veiligheidshandleiding (8 pagina's)

Setting the ISDN Territory

Before you connect an AT-AR020 or AT-AR021 PIC to the ISDN network, check

that the ISDN territory is set correctly for your region.

For more information, see the Installation and Safety Guide included with your

switch or router. You can also download the complete documentation for your

switch or router from www.alliedtelesis.com/support/software/.

Set the territory, using the command:

set system territory={australia|china|europe|japan|korea|

newzealand|usa}

In Australia only:

• To use the Micro service, set the territory to australia.

• To use the OnRamp service, set the territory to europe.

Save the configuration.

Save your configuration to a new file by using the command:

create config=filename.cfg

Then set the router to load this file when it restarts by using the command:

set config=filename.cfg

We recommend leaving the boot.cfg file unchanged, in case you need to revert

to the original default configuration.

See the AlliedWare

configuring ISDN.

Operating System Software Reference for more information on

Port Interface Card