Dell PowerConnect 6224 Release Release - Pagina 15
Blader online of download pdf Release Release voor {categorie_naam} Dell PowerConnect 6224. Dell PowerConnect 6224 34 pagina's. Powerconnect 6200 series
Ook voor Dell PowerConnect 6224: Specificaties (2 pagina's), Handleiding voor planning en voorbereiding (12 pagina's)
Pagina afdrukken
PowerConnect 6224/6224F/6224P/6248/6248P Release Notes
Trap Configuration
In previous versions of the software, configuration of the flags for controlling traps was scattered about in a
number of places.
snmp-server enable traps is now a common command for configuring all trap flags. The legacy
commands are preserved for backward compatibility. Also note that the keyword "trap" has changed to the
plural "traps".
SNTP Server Priority
The server priority is now available from the show sntp configuration command. Previously it was only
configurable.
GARP Leave Timer
The valid range for the GARP leave timer has been changed to 20-600 centiseconds.
IP Multicast Static Route Configuration
The command for configuring a static IPv4 multicast route has changed to ip mroute. The ip multicast
staticroute command is deprecated.
Support for Long User Names
The show users, show users accounts, and show users login-history commands have changed. The long
parameter has been added to these commands to support long usernames.
Flow Control
Flow Control is enabled by default.
Note: When you upgrade a switch to this release, flow control is automatically enabled. If your previous
configuration had flow control disabled, you must disable flow control after the upgrade to match the
previous configuration.
VLAN Limit Increases
MAC based VLAN limit was increased from 128 to 256.
Subnet based VLAN limit was increased from 64 to 128.
System Firmware Version 3.2.0.6
Page 13