Dell PowerConnect 7024P Firmware upgraden - Pagina 10

Blader online of download pdf Firmware upgraden voor {categorie_naam} Dell PowerConnect 7024P. Dell PowerConnect 7024P 24 pagina's. Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Ook voor Dell PowerConnect 7024P: Release-opmerkingen (27 pagina's)

Pagina afdrukken

Dell PowerConnect 7024P Firmware upgraden

Upgrading PowerConnect Switches from Version 2.x.x.x or 3.x.x.x or

4.x.x.x or 5.x.x.x to 5.1.9.3 Firmware

- # of sectors per FAT copy:

- # of FAT table copies:

- # of hidden sectors:

- first cluster is in sector #

- Update last access date for open-read-close = FALSE

PCI unit 0: Dev 0xb820, Rev 0x11, Chip BCM56820_B0, Driver BCM56820_A0

SOC unit 0 attached to PCI device BCM56820_B0

Adding BCM transport pointers

Configuring CPUTRANS TX

Configuring CPUTRANS RX

Instantiating /download as rawFs,

Formatting /download for DOSFS

Instantiating /download as rawFs, device = 0x20001

Formatting.../download: file system is marked clean, skipping check

OK.

<186> Apr 6 03:09:42 0.0.0.0-1 General[1073741072]: bootos.c(225) 1 %% Event(0xaaaaaaaa)

Instantiating RamCP: as rawFs,

Formatting RamCP: for DOSFS

Instantiating RamCP: as rawFs, device = 0x30001

RamCP:/

- disk check in progress ...

RamCP:/

- Volume is OK

OK.

(Unit 1 - Waiting to select management unit)>

Applying Global configuration, please wait ...

Applying Interface configuration, please wait ...

console>

6. After the switch has finished rebooting, log in and verify that the firmware has been updated to the

version using the show version command. A single switch will typically reboot in around two minutes. A

stack may take significantly longer to complete the upgrade process.

console#show version

System Description................ Dell Ethernet Switch

System Up Time.................... 0 days, 00h:02m:36s

System Contact....................

System Name.......................

System Location...................

Burned In MAC Address............. 5C26.0AB2.4327

System Object ID.................. 1.3.6.1.4.1.674.10895.3023

System Model ID................... PC8024

Machine Type...................... Powerconnect 8024

unit image1

---- ----------- ----------- -------------- --------------

4.2.1.3

7. The switch is now ready for normal operation. Verify the configuration and make any changes needed prior

to connecting the switch to the operational network.

NOTE:

After upgrading to the 5.1.9.3 firmware, one can emulate the earlier

firmware default behavior for privileged exec (enable) mode access by

setting the enable authentication method to enableList.

console(config)# line telnet

console(config)# enable authentication enableList

console(config)# exit

136

device = 0x20001

device = 0x30001

image2

current-active next-active

5.1.9.3

image2

Page 7

5.1.9.3