Allied Telesis AT-AR027 VoIP-FXS Handleiding voor snelle installatie - Pagina 9
Blader online of download pdf Handleiding voor snelle installatie voor {categorie_naam} Allied Telesis AT-AR027 VoIP-FXS. Allied Telesis AT-AR027 VoIP-FXS 10 pagina's. Port interface card
Ook voor Allied Telesis AT-AR027 VoIP-FXS: Installatiehandleiding (13 pagina's), Installatiehandleiding (13 pagina's), Gegevensblad (1 pagina's), Gegevensblad (1 pagina's), Installatie- en veiligheidshandleiding (8 pagina's)
Pagina afdrukken
Quick Install Guide
C613-04020-01 REV H
Download and save the firmware file to a location of your choice. Then load
the boot code to the router's flash. If you have enough space in your flash, also
load the application code to flash to allow downloading without an external
tftp server.
1.
Set the boot file on the router, using the command:
SET VOIP BOOTCODE=filename SERVER={ipaddr|flash}
where:
•
filename is a file name of the form
lowercase letters (a-z), digits (0-9) and the hyphen character (-).
•
ipaddr is a tftp server IPv4 address in dotted decimal format. Use the
PING command to make sure the IP address is reachable by the router.
•
flash is the application code already stored in the router's flash.
This file should already be in the router's flash. Set the SERVER parameter to
"flash" if you wish to download the application code from flash.
2.
Set the protocol image filename in the TFTP server, using the command:
SET VOIP FILE=filename PROTOCOL={H323|SIP} TYPE={FXS|FXO}
where:
•
filename is a file name of the form
lowercase letters (a-z), digits (0-9) and the hyphen character (-).
3.
Set the preferred router interface for the VoIP traffic, using the command:
SET VOIP PUBLIC INTERFACE=interface
where:
■
interface is a port interface name formed by concatenating a layer 2
interface type, an interface instance, and optionally a hyphen followed by a
logical interface number in the range 0-15 (for example, eth0). If a logical
interface is not specified, 0 is assumed (that is, eth0 is equivalent to eth0-0).
4.
Initiate the download of the H.323 or SIP protocol image, using the command:
ENABLE VOIP PROTOCOL={H323|SIP} [ENGINE={engine}]
where:
■
engine is an engine name formed by concatenating a VoIP interface type
and an engine instance (for example, fxs2). A fully qualified engine name
may also be specified (for example, bay0.fxs0 or nsm0.bay1.fxs0).
If the TFTP download fails, possibly due to an incorrect filename or the
unavailability of the TFTP server, then it can be restarted once the problem has
been corrected by re-entering the ENABLE VOIP PROTOCOL command.
Once the firmware is downloaded, all the LEDs should turn off. The figure
below shows an example of the screen output of the firmware download
process.
. Valid characters are
filename.bin
. Valid characters are
filename.bin
9