Dell PowerConnect BI-RX-16 Aan de slag handleiding - Pagina 25
Blader online of download pdf Aan de slag handleiding voor {categorie_naam} Dell PowerConnect BI-RX-16. Dell PowerConnect BI-RX-16 32 pagina's. Powerconnect b-rx series
Pagina afdrukken
Attaching a PC or terminal to the Console port or Ethernet port
The management module's Console port (which has a male DB-9 serial connector), and 10BaseT/100Base TX
Ethernet port (which has an RJ-45 UTP connector) allow you to attach a PC or terminal. From the Console port, you
can access the PowerConnect B-RX Series switch's CLI directly from the PC or terminal or through a Telnet
connection to the PC or terminal. From the Ethernet port, you can access the PowerConnect B-RX Series switch's CLI
or Web management interface directly from the PC or terminal or through a Telnet connection to the PC or terminal.
Before performing this task, you need the following items:
•
PC running a terminal emulation application or a terminal.
•
If connecting the PC or terminal to the Console port, a straight-through EIA or TIA DB-9 serial cable with one end
terminated in a female DB-9 connector and the other end terminated in a male or female DB-9 or DB-25
connector, depending on the specifications of your PC or terminal. You can order the serial cable separately from
Brocade or build your own cable. If you prefer to build your own, refer to your hardware installation guide.
•
If connecting the PC or terminal to the Ethernet port, a Category 5 UTP crossover cable, which you must supply.
For information about the management port pin assignments, refer to your hardware installation guide.
Follow the steps given below to attach a PC or terminal to the Console port or Ethernet port.
1. Connect a PC or terminal to the Console port or Ethernet port using the appropriate cable.
2. Open the terminal emulation program, and set the session parameters as follows:
•
Baud: 9600 bps
•
Data bits: 8
•
Parity: None
•
Stop bits: 1
•
Flow control: None
Attaching the management module's Ethernet Port to a network
The management module's 10BaseT/100BaseTX/1000BaseTX Ethernet (management) port (RJ-45 UTP connector)
allows you to connect the management port to a network. A management station in your existing management
network can then access a PowerConnect B-RX Series switch using the switch's Network Manager.
To attach the management module's Ethernet port to a network, you need a Category 5 UTP straight-through cable
(not supplied by Dell). Connect one end of the straight-through cable to the management port and the other end to
the network.
Powering-on the power source
After you complete the hardware installation, you can power-on your power source.
1. Verify that all modules and power supplies are fully and properly installed and no module slots are uncovered.
CAUTION
If you do not install a module in a slot, you must keep the slot blank in place. If you run the chassis with
an uncovered slot, the system may overheat.
PowerConnect B-RX Series Getting Started Guide
53-1001682-03
25